User manual SILVERCREST SPUV 90 A1 PROJECTION ALARM CLOCK

[. . . ] Never open the housing of the device or of the mains power adapter (not supplied) and do not attempt to repair the device yourself, it does not contain any user serviceable elements. This device is not intended for use by individuals (including children) with restricted physical, physiological or intellectual abilities or deficiences in experience and/or knowledge unless they are supervised by a person responsible for their safety or receive from this person instruction in how the device is to be used. Children should be supervised to ensure that they do not play with the device. Place the device in an open and well ventilated area so that heat pockets cannot be created within it. [. . . ] Place the projection clock onto a level surface. Position the projection clock such that the projection lens q is directed onto an empty surface. The distance from the projection lens to the projection area (ceiling or wall) must lie between 0, 4 m and 3 m. Using the sound level controller VOLUME h, select the desired sound level. The frequencies can be read off from the frequency scale s. As soon as you have found a position with good reception from your desired radio station, leave the telescope aerial a in this position. Select and set the desired radio station, and the sound volume, with which you wish to be woken (see also chapter Radio Operation). At the programmed time the radio will now switch itself on. Press the button o to switch the radio off until the following day. AL2 u until a symbol is no longer shown next to the indicator for the alarm function resp. After about 5 seconds the device returns to just a time display and the indicator for the alarm function disappears. At the programmed time the alarm tone will now switch itself on. Press the button o to switch the alarm tone off until the following day. AL2 u until a symbol is no longer shown next to the indicator for the alarm function resp. After about 5 seconds the device returns to just a time display and the indicator for the alarm function disappears. Press the button o to switch the alarm function off until the following day. When used properly, the radiation from the projection of the display is not at all dangerous!However, avoid looking directly into the light beam and do not aim the beam at other persons or at animals. To display the time correctly on a wall or the ceiling, the hinged projection element needs to be swivelled into the correct position and the room must be appropriately darkened. Press the button PROJECTION LIGHT e once again for 2 seconds to switch the time projection off. Never permit fluids to permeate inside the device. Keep the device and the ventilation openings clean at all times. [. . . ] The warranty period will not be extended by repairs made under warranty. this applies also to replaced and repaired parts. Any damage and defects extant on purchase must be reported immediately after unpacking the appli ance, at the latest, two days after the purchase date. Repairs made after the expiration of the warranty period are subject to payment. [. . . ]