User manual SILVERCREST SRD 250 A2

[. . . ] These operating instructions are a component of the SRD 250 A2 Clock Radio (henceforth designated as the appliance) and they supply you with important information about the intended use, safety and connection as well as operation of the appliance. These operating instructions must be kept available close to the appliance. They are to be read and used by anyone assigned to operate and repair faults in the appliance. Retain these operating instructions and pass them on to any future owners with the appliance. [. . . ] Do not place the appliance in a hot, wet or very humid location or in the vicinity of flammable materials. The surfaces of furniture may contain components that can affect the rubber pads of the appliance and could soften them. if necessary , place a covering under the appliance's rubber pads. The mains power socket must be easily accessible so that, in an emergency, the plug can be quickly withdrawn from the socket. Before connecting the appliance compare the connection data (Voltage and frequency) on the rating plate with that of the mains electric source. This data must be compatible to avoid possible damage to the appliance. Make sure that the appliance's connection cable is not damaged and is not laying over hot surfaces and/or sharp edges. Make sure that the connection cable is not tightly stretched or bent. 5 V batteries (type R6/LR6/AA/Mignon) you avoid losing the programmed time of day and wake time in the event of mains power loss. The batteries make sure that the internal clock continues to run even during a power outage. When power is restored the correct time appears automatically in the display 2 . NOTICE The display, radio and alarm do not function with batterypower alone. Open the cover of the battery compartment 11 on the bottom of the device. For correct polarity make sure that the batteries are inserted according to the diagram in the battery compartment 11 . Close the battery compartment 11 by replacing the cover and allowing it to lock into place. Plug the mains power plug into a wall socket. In this chapter you receive important information for the handling and operation of the appliance. Press the button TIME 13 once again to accept the adjustment. NOTICE The time of day will revert back to - -:- - if the device is disconnected from the mains power supply and no batteries have been inserted. With the VOL control 18 set the desired sound level. press briefly the /BAND button 9 to set the desired frequency band. With VHF reception the MHz/FM-LED 4 lights up, with MW reception the kHz/AM-LED 5 lights up. [. . . ] This product is subject to the provisions of European Directive 2002/96/EC. Dispose of the appliance through an approved disposal centre or at your community waste facility. observe the currently applicable regulations. In case of doubt, please contact your waste disposal centre. [. . . ]