User manual SILVERCREST SSMS 600 A1 HAND BLENDER SET

[. . . ] Do not crease or crimp the power cable and place the power cable in such a way as to prevent anyone from stepping on or tripping over it. Arrange for defective power plugs and/or cables to be replaced at once by qualified technicians or our Customer Service Department. You may not open the motor unit housing of the hand blender. Should you do so, appliance safety can no longer be assured and the warranty becomes void. [. . . ] Ensure that the lugs on the edge of the bowl are guided into the recess on the lid. Place the motor unit 3 on the lid 5 so that the arrow points to the symbol . Turn the motor unit 3 until the arrow points to the symbol . Note: Should you wish to keep liquids/foods in the chopper, you can remove the base of the measuring beaker and use it as a lid. For this, carefully remove the lid 5 and motor block 3 and, if needs be, the blade 6. Loosen the bottom of the chopper and put it on the chopper. Included are 2 dowels and 2 screws to enable the wall bracket q to be installed. ³ Mark the positions of the drill holes using the wall bracket q. ³ Position the openings of the wall-holder q over the drill holes and then secure it using both of the screws. contents squirted out may cause scalding. Before you clean the hand blender, unplug the appliance from the power socket. Under no circumstances may the motor unit 3 be cleaned by immersing it in water or holding it under running water. Allow the appliance to cool down for 2 minutes before switching it on again. Note: When you beat cream with the whisk 9, hold the container at a slant during the beating. In this way the cream will be thicker quikker. Ensure that cream cannot be sprayed out of the container while it is being beaten. When you have assembled the hand blender for your particular purpose, insert. ³ The plug into the mains power socket. Hold down the switch 1 to process the foodstuffs at the standard speed. ³ Hold down the turbo-switch 2 to process the foodstuffs at the higher speed. ³ When you have completed processing the foodstuffs, simply release the switch. Reassemble the liquidiser after use and cleaning to prevent injury from the exposed knife blade. [. . . ] this applies also to replaced and repaired parts. Any damage and defects extant on purchase must be reported immediately after unpacking the appliance, at the latest, two days after the purchase date. Repairs made after the expiration of the warranty period are subject to payment. Do not dispose of the appliance in your normal domestic waste. [. . . ]