User manual SILVERCREST SWW 1500 A1

[. . . ] These operating instructions are a component of the Thermal wave heater SWW 1500 A1 (subsequently refered to as the device) and provide you with important information for proper use, safety, connections as well as operation of the device. These operating instructions must be constantly kept available close to the device. They are to be read and applied by anyone assigned to operate, and/or repair faults to the device. Retain these operating instructions and pass them on, together with the device, to any future owners. [. . . ] The minimum distances of the housing from other objects must be maintained, they are; 100 mm at the sides, 300 mm above, 150 mm below (with wall mounting) and 500 mm in front. Do not stand and/or hang the device in a hot, wet or very moist environment or in the vicinity of flammable materials. The mains wall socket must be easily accessible so that the mains power cord can be easily removed in an emergency. Environment temperature range: +5 to +45 °C Humidity (no condensation): 5 - 90 % DANGER Fire hazard through contact with materials!The risk of fire exists if the heating elements come into contact with flammable materials!Do not place and/or hang the device in the vicinity of curtains and other flammable materials. Draperies) to come into contact with the device. Before initial use remove all packaging materials and all transport securing devices from the device. NOTICE With initial use, for a brief period, a light odour accumulation can occur. For safe and faultless operation of the device with electrical connection observe the following advice: CAUTION Before connecting the device compare the connection data (voltage and frequency) on the rating plate with that of your mains power supply. This data must be in agreement so as to avoid damage to the device. Make sure that the mains power cord is not damaged and is not running over hot surfaces and/or sharp edges. Make sure that the mains power cord is not stretched or knoted. CAUTION For assembly place the device on a soft underlay such as, for example, a carpet in order to avoid damages. Fold the carrying handle 10 backwards and place the device with the underside upwards, on a soft underlay. WARNING Make sure that when you are drilling you do not damage any electrical wires or other installations in the wall such as water pipes. the supplied rawlplugs are only suitable for a mounting on concrete or stone. Before starting the installation, please check your installation location carefully for its suitability for the rawlplugs. NOTICE When selecting the mounting location make sure that a suitable mains wall socket is located within the plug-in radius of the mains power cord. Slide the upper wall brackets B into the holding fixtures C on the device's rear panel and firmly screw these, together with the angle bracket D and the lower wall brackets B , to the rear panel of the device. For this purpose use the 7 screws M4 x 13 mm (see diagram Wall bracket assembly). Diagram Wall bracket assembly Mark two drill holes at a height of 600-650 mm and at a distance of 330 mm. [. . . ] Allow the device to cool for a few minutes. switch the device off and on at the main switch POWER 6 . If the indicator continues to appear get in touch with the customer service department. The device will not switch on The mains power socket is not providing power The device is not providing heat. [. . . ]