User manual SILVERCREST SZA 28 A1 DVB-T INDOOR AERIAL

[. . . ] Any utilisation other than as described here is not permitted and could lead to damage and injuries. Separation from the mains power network: The controller does not completely separate the antenna from the mains power network when it is switched off. in addition , the antenna consumes current in the off-state. To completely separate the antenna from the mains power supply, the plug must be disconnected from the mains power socket. [. . . ] For the reception of DVB-T transmitter signals you need a TV with an integrated DVB-T Tuner or an additional DVB-T Receiver (DVB-T signals are not available everywhere). the indoor antenna has to be positioned correctly for the proper reception of programme signals. The following antennas are available for this: 1 two telescoping antennas for VHF and UKW reception that tilt and rotate by 180° and 2 one oval-shaped antenna for UHF reception that tilts and rotates by 100°. µ When you want to use the room antenna for radio reception, utilise the Adapter Coaxial socket/Coaxial socket 8. connect the Adapter Coaxial socket/Coaxial socket 8 with the antenna cable. Connect the anntenna cable with Adapter Coaxial socket/Coaxial socket 8 to the 75 Ohm connector on your stereo system. µ µ µ Pull out both telescopic antenna 1 and adjust these until the best reception is obtained. Adjust the oval antenna 2 by turning or tilting until the best reception is obtained. To connect the room antenna to a DVB-TReceiver with an F-socket, the Adapter F-Plug/ Coaxial socket 7 must be used. connect the Adapter F-Plug/Coaxial socket 7 with the antenna cable. Screw the antenna cable with the Adapter F-Plug/Coaxial socket 7 to the F-socket of the DVB-T-Receivers. You can regulate the amplifier gain by turning the regulator 4 on the front of the appliance: µ Switch on the indoor antenna by turning the regulator 4 to the right. µ Turn the regulator 4 completely to the left until it clicks to switch off the indoor antenna. µ Insert the power plug of the indoor antenna into the power socket. Reception disruptions, such as an unclear or distorted picture could have the following causes: · For this reason, reorient the indoor antenna every time after changing the station. Try to eliminate the interference if, for example, it is caused by other appliances (mobile telephone, micro-wave, etc. Try to eliminate the interference by reducing the amplifier gain by turning the regulator 4 anti-clockwise. The reception characteristics of the indoor antenna are only good if you are close enough to the broad-casting station. Before cleaning, always pull the plug out of the plug socket. Never submerge the indoor antenna into water or other liquids during cleaning. [. . . ] Only in this way can a post-free despatch for your goods be assured. The warranty covers only claims for material and maufacturing defects, but not for transport damage, for wearing parts or for damage to fragile components, e. This product is for private use only and is not intended for commercial use. The warranty is void in the case of abusive and improper handling, use of force and internal tampering not carried out by our authorized service branch. [. . . ]