User manual SIMA CP-150

[. . . ] User's Manual CP-150 Image Bank Sima Products Corporation Image Bank CP-150 Preface About this manual Introduction This manual is designed to make using the CP-150 Smart Remote Control as easy as possible. Information in this document has been carefully checked for accuracy; however, no guarantee is given to the correctness of the contents. The information in this document is subject to change without notice. © Copyright 2001 This document contains proprietary information protected by copyright. No part of this manual may be reproduced by any mechanical, electronic or other means, in any form, without prior written permission of Sima Products Corp. Trademarks- all trademarks and registered trademarks are the property of their respective owners. FCC Rules & Warning This device complies with Part 15 of the FCC Rules. [. . . ] Insert the "USB Device Driver" disk to Mac, and download "usb2ide10F0" from the folder \Mac\ in the "USB Device Diver" disk to your Mac, then double click this file. Adapters are also available to use Sony MemoryStick and MMC cards. Trouble with unit and memory cards. 1. Make sure the unit is not connected to your PC or MAC and the USB cable is removed from the CP-150. (When USB cable is inserted in USB port on CP-150, it cannot read memory cards. ) 2. Make sure only the power cord is connected. With unit off (LCD Display lights not lit) insert memory card and then power up the CP-150. If the memory cards are used (even just viewed) on a Mac with a reader, you will not be able to use the cards in the CP-150 unless they are re-formatted by the camera. When viewed with a MAC reader, Mac files are automatically be added to the CP-150. These will cause the copy process in the CP-150 to fail and the files will not be transferred. Trouble with unit and PC connection. 1. Plug in the power cord to the CP-150 No change on CP-150 panel Connect the USB cable to the CP-150 CP-150 Powers up, display flashes, HD on, ready light stays on. Does the computer recognize that something was just attached? 11 Image Bank Troubleshooting a CP-150 with a MAC Operating system: MAC OS9. 0 or higher 1). 2). Troubleshooting Make sure the unit and the USB cable is not connected to the MAC. Install drivers in the following order a). after MAC recognizes the CD go to the MAC directory on the CDROM and copy the file USB2IDEDriver_20f4. HQX to the desktop 3). Double click this file and it will expand into 2 files 4). Double click the file with the icon "VISE" and this will install the driver. Connect the power cord to the CP-150 6). CP-150 Powers up, display flashes, HD on, ready light stays on. Reboot your MAC with the CP-150 connected 11). The MAC should recognize the CP-150 on boot up and ask to initialize the drive. The MAC should now recognize the CP-150 as a hard disk. PC-related questions Question: My CP-150 will not recognize my SmartMedia (SM) or CompactFlash (CF) cards when it is connected to my computer. Answer: The CP-150 acts as 2 separate devices. [. . . ] Make sure your system meets the minimum requirements listed below before proceeding. Warning: All files will be erased during this procedure. System requirements: PC with Windows98, Windows98SE (second edition), WindowsME, Windows2000 or MAC OS 9. 0 or higher. If not already running, power up your PC. Make sure that your USB connectors are working and all necessary drivers have been loaded (refer to owner's manual or contact your computer vendor or sales person for more information). [. . . ]