User manual SIMA VS-502

[. . . ] 5 Input A/V Switcher with Component Video, Digital Audio, Automatic Input Mode and Volume Stabilizer Model VS-502 User Manual Online Product Registration http://www. simacorp. com Package Contents: 1 - VS-502 A/V Switcher Unit 1 - Power Adapter, (120VAC input, 15VDC output) 1 - IR Remote Control, with Batteries 1 - Instruction Manual Caution: IMPORTANT SAFEGUARDS FOR AUDIO PRODUCTS. PLEASE READ CAREFULLY THE FOLLOWING IMPORTANT SAFEGUARDS THAT ARE APPLICABLE TO YOUR EQUIPMENT 1. Read instructions - All the safety and operating instructions should be read before the appliance is operated. Retain instructions - The safety and operating instructions should be retained for future reference. [. . . ] Likewise, connect the outputs on the VS-502 to the inputs on the TV/VCR/Receiver/etc. . . Note: If you have one or more devices which are not stereo and have a single audio output, you have two options. 1) Use a "Y" adapter (available from any electronics store) to split the mono signal into two signals to feed both the Left and Right inputs on the VS-502. 2) Use just the left connector for the audio of that source. Page 9 Fig. 6 - Basic Hook-up #2: Connecting Different Video Types Below shows a hook-up with 3 input sources. Below shows inputs 1, 2 and 3 being used. Input 1 is being used as a composite video input with stereo left and right audio. Input 2 shows how to connect S-Video while using the optical digital audio input. Input 3 unlike (figure 5) is now being used as a component video input along with a coaxial digital audio connection. The VS-502 component output goes to the TV monitor along with the left and right stereo audio. The digital audio goes to the stereo receiver. Input 1 and 2 are being upconverted from composite and S-Video to component video. Figure 6, VS-502 Notes: Remember to select the A/V or AUX input on the TV. Is does not convert the digital signal to analog L+R signals or vise versa. This device will convert optical to coaxial and vice versa. Page 10 Operation When AC power is first applied, all outputs will be muted and all the lights will come on for three seconds and then go out. The Power / Stand-by light will be lit dim red. The Auto Input and Volume Stabilization modes will be active as default. When the unit detects an active video input (composite, SVideo, or component video), the Power / Standby light will turn off and the active input will be selected. Power As long as AC power is not lost, the previous status (last selected input, Volume Stabilizer mode and AUTO SELECT status) will be resumed when Power / Stand-by is pushed. If AC power was lost, the unit will default with input #1 selected, Volume Stabilization on and Auto Input on. Inputs Pushing a input button on either the front panel or on the IR remote will cause the current input and associated LED to go off and the new input to come on. Auto Input Mode If the Auto Input mode is on, as a new input becomes active, the VS-502 will automatically change to the new input. If you want to go to another A/V source, simply select the input using the front panel button or the remote. If you don't want the VS-502 to automatically select an active input, turn the Auto Input mode off. Please note when you activate Auto Input mode, it scans the inputs when the VS-502 is on or in the stand-by mode. A new input becoming active will cause the unit to wake from standby, and select the new input. [. . . ] Push STANDBY button so unit is in the ON mode. Your TV is using both composite and S-Video inputs. Use only one or the other to feed into the VS-502 or into your TV. Is the video cable connected from the device to the VS-502? [. . . ]