User manual SIMRAD HOS 192 DATASHEET REV A

[. . . ] Added information about mandatory UPS systems. Added information related to new audio output. Cabling information reorganized. Copyright ©2009 Kongsberg Maritime AS The information contained in this document remains the sole property of Kongsberg Maritime AS. No part of this document may be copied or reproduced in any form or by any means, and the information contained within it is not to be communicated to a third party, without the prior written consent of Kongsberg Maritime AS. [. . . ] Ok Vertical gain Check the vertical gain read-outs. 1 Press the Mode 2 button to select mode 270°/Vertical. 3 Click the Vertical tab to bring up this menu. 4 Press the Gain V- and Gain V+ buttons in the Gain field on the Operator Panel repeatedly. Gain VGain V+ 5 6 Check that the Gain read-out in the Vertical menu changes from 0 to 50. Ok Vertical range Check the vertical range read-out. 1 Press the Mode 2 button to select mode 270°/Vertical. 2 Press the Range V- and Range V+ buttons in the Range field on the Operator Panel repeatedly. Range VRange V+ 3 4 Check that the Range read-out in the Vertical menu changes accordingly. Ok Full screen Check the Full screen function. This function will remove the menu system from the sonar screen. 1 Press the Menu button in the Cursor field. Menu 307531/C 107 Simrad HOS 192 2 3 4 Check that the menu disappears for a full screen echo presentation. Press the button once again to recall the menu. Move the cursor to any position on the screen. Press the Position Track button in the Train field. Position Track 5 6 7 Check that a circle appears at the cursor, and that the audio line moves to the circle. Press the Target Track button in the Train field. Target Track 8 9 Check that a violet circle appears at the cursor, and that the audio line moves to the circle. Press the Manual button in the Train field. Manual 10 Check that the violet circle disappears. 11 Press the Auto Search button in the Train field. Auto Search 110 307531/C Start-up procedures 12 Check that the audio line starts a search within the displayed sector limits. 13 Press the Manual button to stop the search. 14 Ok Operating Panel backlight The background light in the Operating Panel can be adjusted on the Display menu. 1 2 3 4 5 Click the Display tab to open the Display menu. Click the right and left side of the button repeatedly. Check that the intensity of the Operating Panel backlight can be adjusted accordingly. Ok Power off Observe the following procedure to switch off the sonar for the remaining tests. [. . . ] p. p = stern transverse water speed, knots A = status, stern water speed, characters A (data valid) or V (data not valid) are used. c. c = stern transverse ground speed, knots A = status, stern ground speed, characters A (data valid) or V (data not valid) are used. 307531/C 225 Simrad HOS 192 VTG Course over ground & ground speed This telegram contains the actual course and speed relative to the ground. $--VTG, x. x, T, y. y, M, z. z, N, g. g, K, a*hh<CR><LF> · · · · · · VTG = telegram identifier x. x, T = course over ground, degrees true y. y, M = course over ground, degrees magnetic z. z, N = speed over ground, knots, resolution 0. 1 g. g, K = speed over ground, km/hr, resolution 0. 1 a = mode indicator VWR Relative (apparent) wind speed and angle This telegram provides the wind angle in relation to the vessel's heading, and the wind speed measured relative to the moving vessel. Note that this telegram format is not recommended for new design. [. . . ]