User manual SIMRAD ITI FAST CHARGER QUICK REFERENCE GUIDE REV D
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual SIMRAD ITI FAST CHARGER. We hope that this SIMRAD ITI FAST CHARGER user guide will be useful to you.
Lastmanuals help download the user guide SIMRAD ITI FAST CHARGER.
Manual abstract: user guide SIMRAD ITI FAST CHARGERQUICK REFERENCE GUIDE REV D
Detailed instructions for use are in the User's Guide.
[. . . ] Safety first Hazards may arise if nickel-cadmium rechargeable batteries are improperly used. The ITI Fast Charger has been designed to only recharge ITI sensors with blue labels. these are powered by sealed nickel-cadmium battery cells. [. . . ] Charging will then be performed in a safe and reliable manner. To ensure safe and correct charging of the ITI sensors, the ambient temperature must be within the specified limits. In low temmperatures, hydrogen gas may be generated inside the sealed battery cell, and this will increase the pressure. Increasing the pressure inside a sealed battery Warnings DO NOT connect the fast charger to ITI sensors with red label. DO NOT start charging if ambient temperature is lower than +15°C (59°F) or higher then +45°C (113°F). DO NOT use the ITI Fast Charger to charge any other equipment than Simrad's blue labeled ITI sensors. DO NOT charge more than one sensor at a time with the same charger. DO NOT charge the ITI sensors with any other charger than those delivered by Simrad. Danger may occur if the charging current is too high or otherwise out of control. dO NOT store the sensor with flat batteries. Recharge the batteries at least once every two months, whether they are used or not. Compartment where hydrogen and oxygen are present may under some conditions result in an explosion. Connecting the ITI Fast Charger to any other equipment than ITI's blue labeled sensors must never be done, as the battery may not be designed for fast charging. ITI sensors with red labels are not prepared for fast charging, and must never be connected to the ITI Fast Charger. [. . . ] To fully charge a sensor battery using maintenance charging only, allow 14 to 16 hours. The charger has a built-in controller to switch from fast charging to maintenance charging when the battery voltage reaches a preset value, or after approximately three hours controlled by the built-in timer. The charger may remain connected for an unlimited time when the lamp is green. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SIMRAD ITI FAST CHARGER
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual SIMRAD ITI FAST CHARGER will begin.
