User manual SIMRAD PI54

[. . . ] Operator manual Simrad PI54 Catch monitoring system (CD11035E) www. simrad. com MAXIMIZING YOUR PERFORMANCE AT SEA 850-165186 / Rev. B Simrad PI54 Catch monitoring system Operator manual Important notice Operation of the PI54 catch monitoring system assumes that the communication between the Operator Unit and the sensors is fully functional. Ensure that the communication channels and update rates defined on the Operator Unit matches those of the sensors. About this document Rev Rev. B Date 02. 12. 05 Written by RBr Checked by KR Approved by KR Revised for SW version 0. 40. New function Trawl Calculator implemented. © 2005 Simrad AS ISBN 82-8066-053-4 All rights reserved. No part of this work covered by the copyright hereon may be reproduced or otherwise copied without prior permission from Simrad AS. [. . . ] Note that a faster update rate will decrease the battery life. · Fast (~5, 5 sec): Recommended for new trawl or changes in rigging to monitor any instabilities or unexpected changes. This mode provides the shortest battery life before charging. · Normal (~14 sec): Recommended for well known trawl behavior with stable situations. Use this setting during normal conditions. · Slow (~34 sec): Recommended to monitoring a stable situation over time. The system will be more sensitive to bad communication conditions due to the slow data update. This mode provides longest operational battery life before charging. System configuration Sensor configuration: The sensor must be configured with a unique sensor number. Select channel number and update rate according to the sensor's configuration. Write down the configuration for future reference. Status & Receiver: The Interference filter must be switched on. Set it to level 9 if you have noise problems from other hydroacoustic sources. Note that with the filter on, it will influence the signal spectrum shown in the Status display. Sensor filter: Switch this filter to Light. Set it to Heavy only if you experience excessive noise. Position Off will provide raw data and fastest possible response. 136 850-165186 / Rev. B Sensors Mounting Location: Place the sensor where you wish to monitor the height. This is normally aft of the headrope at the center of the net. Ensure that you mount the sensor with the reverse side (D) and the echo sounder transducer (E) pointing towards the bottom!The SIMRAD print on the sensor (C) must point up towards the water surface!Mounting: Secure the two forward fastening lugs (A) using two snap hooks and rope. Then, secure the two aft fastening lugs (B) using snap hooks and strong rubber bands. This mounting places the sensor in a cradle supported on all four sides. [. . . ] - The transfer progress can be monitored in the message field. Verify that the new software version is shown in the Status display. 3 4 5 6 7 8 9 10 11 12 13 850-165186 / Rev. B 297 Simrad PI54 Messages The MMI upload program will keep you posted on the process by means of messages. Safety measures The following safety measures have been implemented to minimize the risk of errors during the upload process. · When the software is uploaded from the computer to the PI54 cabinet, the data are stored in a scratch pad (buffer). The data are not transferred to the Flash PROM (the microprocessor's storage area) until all software data have been transferred correctly to the scratch pad. [. . . ]