User manual SIMRAD RD 301

[. . . ] The operator may select alarm depth in the meny. Maximum depth readings are 9999 m and a resolution of 0. 1 m. [. . . ] If Forward is selected, only the readings from the forward transducer is shown, and if Backward is selected, only the readings from the backward transducer is shown. - The Auto selection switches between Forward, Backward and Unknown depending on the NMEA messages available. The led for positions will shift automatically and blink every third second, indicating that the Auto selection is active. If the transducer position is unknown, both leds will be on and blinking. 1 857-164821aa R D 3 0 1 U s er m an u al NMEA Input 1. Accepted messages (NMEA0183, version 2. 30), talker identifier is not processed: - Depth &Draught SDDPT, xxxx. x, xxxx. x, xxxx. x <Cr><Lf> $PSKPDPT, x. x, x. x, x. x, xx, xx, c-c*hh<CR><LF> (used by EA400 and EA600) Transducer location * Echo sounder channel number (0-99) - Depth below transducer Bottom echo strength (0, 9) Maximum range scale in use, meters SDDBT , xxxx. x, f, xxxx. x, M, xxx. x, F) Offset from transducer, meters Water depth relative to transducer, meters - Depth below transducer by EN 250 proprietary sentence shown to the left * Text string, indicating transducer position: FWD/AFT/PORT/STB. If position is not preset by operator, empty field is provided. (only for EN 250) (Cd7019) PANEL MOUNTING A Make a cut out in the Panel (5): 125 x 125 mm. C Unscrew the 4 screws in the frame (3) (one in each corner) and remove the frame. D Put the Monitor (4) in the cut out and mark the 4 centerpoints for the drill in the Panel (1)(2). depends on thickness and material in the Panel). E Use appropriate bolts with diameter 2. 9 mm. Make sure that the screw heads correspond with the cut outs in the frame. Before fixing the monitor (4) in the cut out area in console (1)(2), apply sufficient amount of water sealant compound between the monitor (4) and console (1)(2). Before the frame (3) is remounted, apply sufficient amount of water sealant compound in the inner area of the frame and on the edges of the monitor (4), to ensure that water can not penetrate into the monitor (4). [. . . ] The user must be familiar with the contents of the appropriate manuals before attempting to install, operate or maintain the equipment. Kongsberg Simrad AS disclaims any responsibility for damage or injury caused by improper installation, use or maintenance of the equipment. Copyright © 2003 Kongsberg Simrad AS The information contained within this document remains the sole property of Kongsberg Simrad AS. [. . . ]