User manual SINGER 110W127

[. . . ] To attach: Slide the table on the base and push the table to the right. 1 Free arm sewing Free-arm sewing is used for stitching sleeves, waistbands, pant legs or any other tubular garments. It is also useful for darning socks or mending knees or elbows. For free arm sewing 1 Return the carriage to the home position (refer to page 67). 4 Hook your finger on the bottom of the fillet and draw the fillet out to the left. [. . . ] Turn the power switch off. 1 1 Draw the thread from the spool. Hold the thread with both hands and pass the thread under the thread guide plate. Tug the thread until it snaps. 2 2 Draw the thread down along the right channel and around the bottom of the guide plate. 3 3 4 Pull the thread up along the left channel to the thread take-up lever. Firmly draw the thread up to the take-up lever and down into its eye from the right to the left, while holding the thread at the spool. 4 5 5 Then pull the thread down along the left channel and through the lower thread guide. Slide the thread behind the needle bar thread guide on the left. Thread the needle with the automatic needle threader (refer to the next page). 6 6 7 7 12 1 2 Using the Automatic Needle Threader Turn the power switch on and lower the presser foot. 1 Hold the end of the needle thread gently. 2 Press the auto needle threader button . The threader lowers automatically and the hook comes out through the needle eye from behind it. 3 Pull the thread down around the thread guide, then pass the thread from the right and under the hook as shown. 4 3 4 Draw the thread to the left and slip it into the slit of the thread holder from the bottom and cut the thread with the thread cutter as shown. Attaching the presser foot Place the presser foot you wish to use so that the pin on the foot lies just under the groove of the foot holder. Lower the presser bar to lock the foot in place. Button sewing foot T Insert the rear pin on the foot into the groove of the foot holder. Gently lower the presser bar while holding the foot with your fingers. Darning foot P-2 Loosen the thumbscrew and remove the foot holder. Attach the darning foot P-2 to the presser bar putting the pin on the needle clamp screw. Tighten the thumbscrew firmly with the screwdriver. Even feed foot Loosen the thumbscrew and remove the foot holder. Attach the even feed foot to the presser bar with the lever over the needle clamp screw and secure it with the thumbscrew. Embroidery foot P Loosen the thumbscrew and remove the foot holder. Attach embroidery foot P to the presser bar from behind. [. . . ] 2 Low bobbin thread warning The low bobbin thread warning level can be adjusted with the "+" or "­" key. 3 Grid on/off To show the grid, press the on/off key to check the box. To hide the grid, press the on/off key again to uncheck the box. 4 Grid size The grid size can be changed by pressing the "+" or "­" key. 3 Grid Line Grid Size 10mm Register on off 4 X 5 6 Rayon 40 Polyneon 40 Poly Sheen Polyester 40 Rayon 40 5 Embroidery maximum speed The maximum embroidery sewing speed can be changed from 400 to 800 spm in 100 spm intervals by pressing the "+" or "­" key or with the speed control slider. [. . . ]