User manual SINGER 1116

[. . . ] To disconnect, turn all controls to the off ("O") position, then remove plug from outlet. To unplug, grasp the plug, not the cord. The sound pressure level under normal operating conditions is 75dB(A). Please turn off the machine or unplug when the machine is not operating properly. [. . . ] (2) - Draw thread from spool through the upper thread guide (3) and pulling thread through pre-tension spring as illustrated. (4) - Thread tension module by leading thread down right channel and up left channel. (5) During this process it is helpful to hold the thread between the spool and thread guide. - At the top of this movement pass thread from right to left through the slotted eye of the take-up lever and then downwards again. (6) - Now pass thread behind the thin wire needle clamp guide (7) and then down to the needle which should be threaded from front to back. (See page 19 for instructions on how to use the Automatic needle threader. ) - Pull about 6-8 inches of thread to the rear beyond the needle eye. (8) EN Automatic Needle Threader - Raise the needle to its highest position. - Pass the thread in front of the needle around the hook (D) from bottom to top. - Pull the thread through the needle eye. Attention: Turn power switch to off ("O")!EN Sewing Straight Stitch To begin sewing, set the machine for straight stitch. (1) Place the fabric under the presser foot with the fabric edge lined up with the desired seam guide line on the needle plate. (2) Lower the presser foot lifter, and then step on the foot controller to start sewing. (3) 28 EN Reverse Sewing To secure the beginning and the end of a seam, press down the reverse sewing lever (A). Release the lever and the machine will sew forward again. (1) A Removing the Work Turn the handwheel toward you (counterclockwise) to bring the thread take up lever to its highest position, raise the presser foot and remove work behind the needle and presser foot. (2) 1 2 B Cutting the Thread Pull the threads under and behind the presser foot. Guide the threads to the side of the face plate and into thread cutter (B). (3) 30 EN Choosing Stretch Stitch Patterns The stretch stitch patterns are indicated with a blue color on the pattern selector dial. To select these stitches, turn the pattern selector dial to the desired pattern. Then, turn the stitch length dial to the indicator marked "S1". [. . . ] (Voir page 9 pour le numéro de pièce du pied de reprisage/broderie) 49 EN Inserting & Changing Needles Change the needle regularly, especially if it is showing signs of wear and causing problems. For best sewing results always use SINGER® brand needles. insert the needle as illustrated as follows: A. Loosen the needle clamp screw and tighten again after inserting the new needle. [. . . ]