User manual SINGER 112W136

[. . . ] If it still does not fit, contact a qualified electrician to install the proper outlet. Dear Customer: We recommend that for future reference you record the Serial Number of your Sewing Machine in the space provided. Refer to illustration below for location of the Serial Number on your machine. Turn power off. Press speed controller Use hand wheel to raise needle. Lower presser foot. Model No. _________________ Serial No. _______________ Raise presser foot. Correct foot controller for this model is model no. : 4C316B (for North American Territories) To ensure that you are always provided with the most modern sewing capabilities, the manufacturer reserves the right to change the appearance, design or accessories of this sewing machine when considered necessary. [. . . ] The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red. If a 13 Amp (BS 1363) plug is used, a 3 Amp. fuse must be fitted, or if any other type of plug is used. fuse must be fitted either in the plug or adaptor or at the distribution board. Neither cord is to be connected to the earth terminal of a three-pin plug. FOR EUROPEAN AND SIMILAR TERRITORIES: This product is suppressed for radio and television interference with the International Electrotechnical Commission requirements of the CISPR. Machines for Great Britain and some other countries having similar wiring standards are shipped from the factory with a plug for connection to the mains. The wires in this mains lead are coloured in accordance with the following code: Blue: neutral (N) Brown: live (L) As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 5 2 & 5 Stitch Pattern Machines PRINCIPAL PARTS 1. Pattern selector 6 2 & 5 Stitch Pattern Machines STANDARD ACCESSORIES INCLUDED WITH MACHINE Note: Accessories are stored inside Extension table. 7 2 & 5 Stitch Pattern Machines CONNECTING MACHINE Before plugging in your machine, be sure that the voltage and number of cycles indicated on the electrical data table (1), conform to your electrical power supply. Plug the controller (2), into the receptacle, at the right end of the machine. (Thread should be easy to pull) Lower presser foot and again pull down 6"~8" of thread. (Thread should be more difficult to pull) If thread is difficult to pull, tension discs are threaded properly. If thread pulls the same with presser foot up or down go back to step 6 and rethread ensuring thread is pulled into tension disc channel (2). Thread needle from front to back. 15 2 & 5 Stitch Pattern Machines RAISING BOBBIN THREAD Open hook cover (1). Turn hand wheel towards you lowering, then raising needle. Gently pull needle thread to raise bobbin thread. Open hook cover (1). 16 2 & 5 Stitch Pattern Machines SELECTING A PATTERN Note: To make selecting pattern easier move stitch width to "image" position. Turn pattern selector dial to select patterns. STRAIGHT STITCHING Preparation: Refer to "Recommended settings and applications". Place fabric under presser foot and lower foot. Begin sewing. 17 2 & 5 Stitch Pattern Machines Straight Stiitching continued. . . Guide fabric. STITCHING IN REVERSE Secure beginning and end of seam as shown. [. . . ] Wider setting (towards right) makes larger buttonhole and wider cutting space. Moving needle to opposite side above point (C). Raise presser foot, adjust fabric slightly and lower needle into point (C). Make 4 or 5 stitches, ending at point (D). [. . . ]