User manual SINGER 150W4

[. . . ] It has many other special Singer features just like those on big machines. You must learn how to use every part correctly. Before you begin to sew anything, ask Mother to read this book with you. Look carefully at every picture and read every word with her. [. . . ] Fasten all four legs with screws, washers and nuts, which you will find in the envelope. Table of Contents 9 Previous Page | Next Page Little Touch & Sew 67A Setting Up Your Sewing Machine 1. Lift the panel in the tabletop by placing one finger in each of the two finger holds. Lift the sewing machine out of the well and set it aside. Hold the panel by the short end and slide the long end into groove 1 at both sides of the very back of the table. Set the machine in the space at the front of the table. Now you are ready to sew. Table of Contents 10 Previous Page | Next Page Little Touch & Sew 67A Replacing the Machine When you have finished sewing, you can leave the machine in place, or you can put it away and have a handy table for other uses. Lift out the panel, pulling it gently straight up. Place the machine face down in the well. Make sure the ridge on the machine slides into groove 2 on both sides. Grasp the long side of the panel and slide the small side into groove 1 at both sides of the back of the table. Table of Contents 11 Previous Page | Next Page Little Touch & Sew 67A A Name For Everything Your Little Touch & Sew sewing machine has some very important parts. See how fast you can learn every name. Table of Contents 12 Previous Page | Next Page Little Touch & Sew 67A A Job For Everything See how fast you can learn what every part does. Leave about two inches of thread hanging outside of hole. Gently press bobbin winder spring and place bobbin on bobbin winder. The hole you threaded in the rim must face you. Turn hand crank in direction of arrows to wind thread onto bobbin. Wind only a few coils of thread. Table of Contents 14 Previous Page | Next Page Little Touch & Sew 67A How to Wind the Bobbin continued. . . Cut off the extra thread hanging from hole in bobbin rim. Be sure you remove the hand crank if you turn on the power switch. Then continue winding bobbin with the hand crank or with the power switch turned to ON. Be sure to guide the thread with your fingers so that it winds evenly on the bobbin. When bobbin is full, cut the thread about 2 or 3 inches away from the bobbin. Then remove bobbin from bobbin winder. Table of Contents 15 Previous Page | Next Page Little Touch & Sew 67A How to replace the Bobbin 1. [. . . ] Stitch around 3 sides, 1 inch from each edge. The - - - lines show you where to stitch. Make sure the ties that hang over each side are 28 inches long on each side. The -- - -- lines show you where to stitch. [. . . ]