User manual SINGER 151W1

[. . . ] G Electric Hot Plates (only on certain models) H Indicator Light for Electric Hot Plates (only on certain models) - On those models equipped with electric hot plates and ignitor, the indicator light is incorporated into the ignition button. I Ceramic Glass Module (only on certain models) L Cooktop Broiler (only on certain models) NOTICE The stainless steel grease pan and the cast-iron grill, located in the burner and grate packing box, must be installed, respectively, below and above the electric heating element so that the element is enclosed between the two. 12 How To Use Your Appliance The position of the corresponding gas burner or electric hot plate (if present) is indicated on each control knob. gas Burners The burners differ in size and power. [. . . ] However, it is important that the bottom be perfectly flat. Casseroles with thicker bottoms distribute heat more evenly. € Use cookware the diameter of which is at least as large as the cooking area so that all of the heat produced by the heating element is used. This will also increase the life of the pots and of the ceramic glass surface as well. Do not use the same cookware that you use for gas burners because the concentrated heat they produce can deform the bottom of the pot. Therefore, you will not achieve best results when using these pots on the ceramic glass surface. Notice: The glue used to seal the glass surface may leave traces on the appliance. We recommend that the module be cleaned with a non-abrasive cleaner before being used the first time. During the first few hours of use, you may detect the smell of rubber; this will disappear after a short time. It may occur that the cooktop does not function or does not function properly. Before calling customer service for assistance, lets see what can be done. ); - The appliance, during and immediately after use given the heat generated by its use; - The ceramic glass cooking surface (if present) immediately before and after use, as the cooking surface will remain hot for at least a half hour after being turned off; - The appliance when no longer in installed (in this case, all potentially dangerous parts must be made safe). The following should be avoided: - Touching the appliance with wet parts of the body; - Using the appliance with bare feet; - Pulling on the appliance or the power supply cord to disconnect them from the electrical outlet; - Improper and/or dangerous use; - Obstructing the ventilation or heat dissipation slots; - Allowing the power supply cord of small appliances to come into contact with the hot parts of the cooktop; - Exposure to atmospheric agents (rain, sun); - Using flammable liquids nearby; - Using adaptors, multiple outlet plugs and/or extensions; - Using unstable or deformed cookware; - Leaving the electric hobs on (or the ceramic glass cooking surface) without cookware on top of them; - Using the ceramic glass cooking surface (if present) as a counter top; - Turning on the radiant heating elements (if present) when there is aluminum foil or plastic objects on the ceramic glass surface; The assistance of qualified personnel must be called upon in the following cases: - Installation (in accordance with the manufacturer's instructions); - When in doubt about the operation of the appliance; - Replacement of the electrical outlet becuase it is incompatible with the plug. Contact service centers authorized by the manufacturer in the following cases: When in doubt about the condition of the appliance after having removed the packing; - Damage to or replacement of the power supply cord; - In the case of a breakdown or malfunction: ask for original spare parts. - In the event the ceramic glass cooking surface breaks. Therefore, LPG tanks, whether empty or partially full, must not be installed or stored in rooms or spaces below ground level (cellars, ect. It is also a good idea to keep only the tank currently being used in the room, making sure that it is not near sources of heat (ovens, fireplaces, stoves, etc. ) that could raise the internal temperature of the tank above 50°C. Installation of built-in stove tops The appliance can be installed next to furniture units which are no taller than the top of the cooker hob. The wall in direct contact with the back panel of the cooker must be made of non-flammable material. During operation the back panel of the cooker could reach a temperature of 50°C above room temperature. For proper installation of the cooker, the following precautions must be taken: a) The hob may be located in a kitchen, a kitonen/diner or bed sitting room, but not in a bathroom or shower room. [. . . ] This panel must be placed at least 20 mm from the bottom of the cooktop itself. Important: When installing the hob above a built-in oven, the oven should be placed on two wooden strips; in the case of a joining cabinet surface, remember to leave a space of at least 45 x 560 mm at the back. When installing on a built-in oven without forced ventilation, ensure that there are air inlets and outlets for ventilating the interior of the cabinet adequately. Gas connection for gas hob The cooker should be connected to the gas-supply by a corgi registered installer. [. . . ]