User manual SINGER 152-11

[. . . ] For the best performance of this piece of precision engineered equipment, a section has been devoted to its maintenance as well as a troubleshooting section. No special skill is needed to operate the COMPACT STEAM PRESS 1. Simply read through the following instructions and learn how to operate the Press. In addition, you will find many useful tips on how to obtain the best possible results. [. . . ] Place Compact Steam Press 1 on a firm level surface. Filling the Water Tank CAUTION: Always disconnect press from electrical outlet when filling with or empty water. Fill the Water Tank with the ironing arm in the raised position. Be careful to avoid spilling water over press when filling. Make sure the Drain is closed by plugging in the Drain Knob 'A' in the direction of the arrow. Unscrew Water Tank Cap 'B' in the direction of the arrow and remove. Using the Water Container, slowly pour up to 2/3 cups (150cc) of water into the Water Tank Fill Hole 'C'. Replace Tank Cap and tighten. 07 MODEL CSP1 3. Turning on the Press Check the voltage printed on the bottom of the Press to be sure it is same as your power outlet. Check to make sure the ON/OFF Switch 'A' is in the OFF position by pressing the side of the switch labeled '0'. Unlock the Pressing Plate and Ironing Board by sliding Locking Knob 'B' to the open position. You may: leave the Pressing Plate in this position for light pressing or for heavier pressure, push down on the Handle until it moves into its lowest position (Automatic Maximum Pressure position). After a few seconds, lift the Handle to raise the Pressing Plate. Regardless of the Steam Control setting, you can produce an extra Burst of Steam to remove stubborn wrinkles. Simply lower the Pressing Plate against the Ironing Board and press down on the Burst of Steam Handle 'D' and release. NOTE: The heater in the Pressing Plate will automatically shutoff after approximately 30 seconds with the Pressing Plate lowered against the Ironing Board. 11 MODEL CSP1 7. Orientation Change of Pressing Plate and Ironing Board For pressing wide and long clothing, press the Orientation Change Button 'A' and turn the Pressing Plate 'C' through 90 degrees. Push down the Orientation Change Lever 'B' and turn the Ironing Board 'D' through 90 degrees. The Pressing Plate and the Ironing Board will be automatically locked in the new position when the Button and Lever are released. CAUTION: Pressing Plate is very hot when ironing. Always cool down the Pressing Plate before changing the orientation. 12 MODEL CSP1 8. When Pressing is Finished Push ON/OFF Switch to OFF (0) position. [. . . ] Place Pressing Cushion under waistband and press. Reposition waistband and continue until entire waistband is pressed. Continue with next pleated area until all pleats are pressed. 21 MODEL CSP1 Curtains Rotate the Pressing Plate and Ironing Board through 90 degrees. Place curtain on Ironing Board as shown and press. [. . . ]