User manual SINGER 157-1

[. . . ] To turn off a burner, turn the knob in the clockwise direction until it stops (it should be on the “•” setting). electric Hot Plate (only on certain models) The hot plate can be: "normal" and "fast". The latter can be identified by a red boss in the center of the hot plate itself. electric Hot Plate (only on certain models) The hot plate can be: "normal" and "fast". [. . . ] € The gas holes are not clogged in the area corresponding to the safety device. The burner does not remain on when set to "Low". Check to make sure that: • The gas holes are not clogged. € There are no draughts near the cooking surface. • The minimum has been adjusted correctly (see the section entitled , "Minimum Regulation"). Check to make sure that: • The bottom of the cookware is perfectly flat. • The cookware is centered correctly on the burner or electric hot plate. € The support grids have not been inverted. If, despite all of these checks, the cooktop does not function properly and problem persists, call the nearest Merloni Elettrodomestici Customer Service Centre, informing them of: - The type of problem. - The abbreviation used to identify the model (Mod. Never call upon technicians not authorized by the manufacturer, and refuse to accept spare parts that are not original. ) that could raise the internal temperature of the tank above 50°C. Installation of Built-in Cooktops The gas cooktops are equipped with type X degree protection against overheating. Therefore, the appliance can be installed next to cabinets, provided the height of the cabinet does not exceed that of the hob. For proper installation of the cooktop, the following guidlines must be followed: a) If the cabinet(s) located next to the cooktop are higher than the cooktop itself, the cabinet(s) must be installed at least 110 mm from the edge cooktop; b) Hoods must be installed in accordance with the instructions contained in the installation manual for the hoods themselves, and no less than 650 mm from the cooktop; c) In the case of the 600 mm cooker hoods, besides following the recommendations in point b), the cabinets should be positioned next to the hood at a height of at least 540 mm from the top since this will make it possible to install the lid and move it correctly. The cabinet should always be installed at a height from the top which allows easy use of pots and pans on the cooker. D) Should the cooktop be installed directly under a cupboard, the latter should be at least 700 mm (millimetres) from the top, as shown in Figure. (exclusively for cooking appliances) Directly to the Outside 700mm min. Detail A Adjacent Room Room to be Vented A e) The dimensions of the cutout for the appliance must be those indicated in the figure. Clamps are provided to fasten the cooktop to counters measuring from 20 to 40 mm in thickness. To fasten the cooktop securely, it is recommended that all the clamps be used. Enlarging the ventilation slot between window and floor. [. . . ] € Unscrew the nozzles using a 7mm socket wrench and replace them with those for the new type of gas. (See table 1 , “Burner and Nozzle Specifications”). € Reassemble the parts following the instructions in reverse order. € On completing the operation, replace the old rating label with the one showing the new type of gas; the sticker is available from our Service Centres. [. . . ]