User manual SINGER 17-22

[. . . ] Any deformities caused by improper fixing could affect the features and operation of the hob. The appliance must be installed on a perfectly level Single-phase connection The hob is equipped with a pre-connected electricity supply cable, which is designed for single-phase connection. Connect the wires in accordance with the instructions given in the following table and diagrams: Voltage and mains frequency 220-240V 1+N ~ 50/60 Hz Electrical cable Wire connection : yellow/green; N: the two blue wires together L: brown and black together GB The thickness of the supporting surface should be taken into account when choosing the length of the screws for the fixing hooks: • 30 mm thick: 17. Use short flat-bottomed screws to fix the 4 alignment springs in the holes provided at the central point of each side of the hob. [. . . ] • The socket is compatible with the plug of the appliance. If the socket is incompatible with the plug, ask an authorised technician to replace it. do not use extension cords or multiple sockets.  Once the appliance has been installed, the power 1 2 3 4 supply cable and the electrical socket must be easily accessible.  The cable must not be bent or compressed.  The cable must be checked regularly and replaced by authorised technicians only.  The manufacturer declines any liability should these safety measures not be observed. 4 Description of the appliance Recommended power levels for various types of cooking: GB A A C Set. switching on the glass ceramic hob Traditional cooking zones (A) consist of circular heating elements. They turn red approximately ten seconds after they have been switched on. Each cooking zone is fitted with a control knob (D) which allows you to select from 12 different temperature settings between a minimum of 1 and a maximum of 12. • Remember that the cooking zones remain relatively hot for at least thirty minutes after they have been switched off. An indicator light provides a warning when residual heat is present (see Start-up and use). • Keep any object which could melt away from the hob, for example plastic and aluminium objects, or products with a high sugar content. Be especially careful when using plastic film and aluminium foil or packaging: if placed on surfaces which are still hot, they may cause serious damage to the hob. • Always make sure that pan handles are turned towards the centre of the hob in order to avoid accidental burns. • When unplugging the appliance, always pull the plug from the mains socket; do not pull on the cable. • Never perform any cleaning or maintenance work without having disconnected the appliance from the electricity mains. • The appliance should not be operated by people (including children) with reduced physical, sensory or mental capacities, by inexperienced individuals or by anyone who is not familiar with the product. These individuals should, at the very least, be supervised by someone who assumes responsibility for their safety or receive preliminary instructions relating to the operation of the appliance. • Do not let children play with the appliance. • Do not look at the halogen lamps in the cooking zones for long if they are present. [. . . ] If water is spilt on the surface, dry it quickly and thoroughly. Some hobs have an aluminium frame which is GB Cleaning the appliance  Do not use abrasive or corrosive detergents (for example, products in spray cans for cleaning barbecues and ovens), stain removers, anti-rust products, powder detergents or sponges with abrasive surfaces: these may scratch the surface beyond repair. Do not use any cleaning or degreasing products which are not suitable for use with aluminium. Never use steam cleaners or pressure cleaners on the appliance. [. . . ]