User manual SINGER 2273 TRADITION

[. . . ] Switch the sewing machine off ("O") when making any adjustments in the needle area, such as threading needle, changing needle, threading bobbin, or changing presser foot, and the like. Always unplug sewing machine from the electrical outlet when removing covers, lubricating, or when making any other user servicing adjustments mentioned in the instruction manual. Never drop or insert any object into any opening. Do not operate where aerosol spray products are being used or where oxygen is being administered. [. . . ] - Pass the thread in front of the needle around the hook (D) from bottom to top. - Pull the thread through the needle eye. 1 C A A B C B D D Attention: Turn power switch to off ("O")!20 GB Raising the Bobbin Thread Hold the upper thread with the left hand. Turn the handwheel (1) towards you (counterclockwise) lowering, then raising needle. Note: If it is difficult to raise the bobbin thread, check to make sure the thread is not trapped by the hinged cover or the Removable Extension Table. 1 Gently pull on the upper thread to bring the bobbin thread up through the needle plate hole. (2) Lay both threads to the back under the presser foot. (3) 22 GB How to Choose Your Pattern The diagram on this page display the stitch patterns available on the machine. Stitches in the top of the diagram are indicated on the Pattern Selector Dial in black. To select the patterns indicated with the black color, turn the Pattern Selector Dial. (d) Use the Stitch Length Dial (c) to adjust the stitch length as desired for the project. Use the Stitch Width Dial (b) to adjust the width of the stitch as desired. Stitches in the bottom row of the diagram are indicated on the Pattern Selector Dial in blue. The blue indicates that the stitch is a stretch stitch pattern, and information on how to sew these stretch patterns is on page 31. The Pattern Selector Dial may be turned in either direction. Cadran de sélection de motifs 24 GB Stitch Width Dial & Stitch Length Dial Function of stitch width dial The maximum zigzag stitch width for zigzag stitching is 5mm; however, the width can be reduced on any patterns. The width increases as you move zigzag dial from "0" - "5". (1) The Stitch Width Dial is also the control for the straight stitch infinite needle position. "0" position is full left, "5" is full right and between "2" and "3" is center needle position. Function of stitch length dial while zig-zag stitching Set the Pattern Selector Dial to zig-zag. The density of zig-zag stitches increase as the setting of stitch length dial approaches "0". [. . . ] insert the needle as illustrated as follows: A. Loosen the needle clamp screw and tighten again after inserting the new needle. The flat side of the shaft should be towards the back. C D A B Attention: Turn power switch to off ("O") before inserting or removing the needle. [. . . ]