User manual SINGER 400W9

[. . . ] 6 Driver Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Software Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Start Program. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 No Comport Error Message . . . . . . . . . . . . . . . . . 8 Open . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] This will copy the command to the command prompt. The next time you plug in your Xchange Box, Windows will automatically recognize your Xchange Box driver. Note Microsoft's Logo compatibility testing is put in place to ensure that users do not incur problems with equipment manufacturers' products. While the Xchange Box is in the process of gaining "formal" Microsoft approval, it has been tested for use under the Windows XP operating system and is Windows XP compatible. The Xchange Box driver should not yield any problems, therefore, select "Continue Anyway" when this warning appears. More information about Microsoft Logo testing can be found at: http://www. microsoft. com/WINLOGO/ hardware/digitalsignature. asp Warning!If you use Windows 2000, Millennium Edition (ME), or XP, you will see this icon appear at the bottom right corner of your screen (near the clock). Before unplugging your Xchange Box, first double-click this icon, select the "USB Conversion Box, " and then click "Stop. " It is now safe to unplug your Xchange Box. NOTE: If you fail to stop your Xchange Box before unplugging it, you will have to reinstall the driver from your installation CD. 7 Xchange Multi-Access Converter START PROGRAM To start the program, either double click the Xchange icon on the desktop OR: 1. Xchange Box appears on your screen as shown below. Your Xchange Box and software is properly installed and ready to use. If you receive any errors when loading the Xchange Box software, call your designated technical support office. TROUBLESHOOTING - NO COMPORT ERROR MESSAGE If you get a message on your screen saying, "Cannot open comport. . . " this usually means the USB driver is not installed correctly. To ensure the program hasn't been opened twice, look at the bottom of your monitor screen between the "Start" button on the left and the clock on the right. If you see a square with "Converter Box" and a picture of the box more than once, you need to exit one of the programs before you may continue. Navigates to the end of the directory. 11 Xchange Multi-Access Converter LOAD The Load function enables you to take designs from most embroidery machine manufacturers' memory cards into the software and write them back to a card for your embroidery machine. Not all pre-programmed memory cards are readable. Some manufacturers have disabled this function for their cards. Insert the preprogrammed memory card into the slot and the Load button will highlight. Click the Load button or Load on the navigation bar and type the number of the desired design. Click Load again to continue adding designs. Or click Load, Browse; a picture of each design on the memory card will be displayed. (Do not attempt to do anything else until all of the designs have been read. ) Select the design you want and click Load. You can keep loading designs one by one until all 6 squares on the Converter Box screen are full. [. . . ] Print Setup Click File, then Print Setup to bring up the print setup dialog box. This dialog box allows you to change the type of printer, properties, paper size and orientation. Exit Click File, Exit to close Color Editor. If you have not saved your work, you will be prompted to do so. VIEW MENU Realistic View Click View, Realistic View. [. . . ]