User manual SINGER 71-103

[. . . ] That the dishwasher is level on the ground. It is worth it: for the longer life span and the correct operation of your dishwasher. 14) Learn to get to know the parts which make up your dishwasher, you will use it better for it. This is where you will find the description of the controls and the internal parts. [. . . ] The at the display: there are two small has begun. wording "No turbo dry" will scroll buttons marked by the letter "H". Across the display along with the These are necessary to set the There's been a wash cycle description. Have Please remember that you cannot select from 1 to 24 hours, and the - you opened the exclude the drying phase from the to go back if you have made a dishwasher door?The word "Delay" appears The countdown stops and then restarts when the electricity on the display. Comes back on or when you shut the door. Everything is under Have you chosen a traditional wash cycle?You should fill it up when the low rinse aid indicator light "O" lights up on and the words "add rinse aid" scroll across the display. To open the dispenser, turn cap C anticlockwise. Take care when you pour in the rinse aid to avoid it overflowing. You can adapt the amount of rinse aid used by the dishwasher: use a screwdriver or a coin to adjust the dosage adjuster F situated underneath the lid C. Follow the diagram to select the desired option. If your dishwasher is linked up to the Ariston Digital system, even if it is switched off the display stays on and indicates the correct time. Normal display D ISHWASHER Language selection Your dishwasher is factory-set to English, but you can change the setting, using button , selecting one of the 7 languages available: Italian, French, German, Spanish, Portuguese, Dutch and Turkish. Follow this diagram to select the desired language. In "demo mode", if you press the "START" button after setting a wash cycle, a demo programme starts and lasts approximately 45 seconds. The wording "demo mode" scrolls across the display and the phases of a normal wash cycle follow one another in succession. To disable the "demo", just select "demo off" or turn the machine off, even, by pressing the START/ RESET button and keeping it pressed while it comes back on: a beep will confirm it has been disabled. Follow this diagram to enable the demo programme. The messages, time and date functions are available if you have had the Ariston Digital system with the GSM node installed in your home. MESSAGGES + TIME + DATE LANGUAGE 1-8 ENGLISH + LANGUAGE language updated 8-8 + TURKCE + DEMO MODE - + + Demo mode Enter the menu by pressing the buttons for approximately 3 seconds, then scroll through the wording using the button until you reach "demo mode", select the latter using the button and then scroll through "demo-on" and DEMO MODE DEMO ON - + DEMO OFF + Suggestions and advice for you. How to look after and protect the dishes you hold dear s Almost all silverware can be cleaned in a dishwasher. [. . . ] When the wash cycle has ended, always remember to turn off the water supply tap and to leave the appliance door ajar. This way, moisture and bad odours will not be trapped inside. Before carrying out any cleaning or maintenance on the dishwasher, always remove the plug from the electricity socket. To clean the exterior and rubber parts of your appliance, do not use solvents or abrasive cleaning products. [. . . ]