User manual SINGER 81-22

[. . . ] That the water inlet and outlet hoses are connected correctly; 3. That the dishwasher is level on the ground. It is worth it: for the longer life span and the correct operation of your dishwasher. 2) Learn to get to know the parts which make up your dishwasher, you will use it better for it. [. . . ] In any case, please read the manufacturer's instructions on the packet. If you use only these products, it is normal for the salt and rinse aid indicator lights to flash permanently after a certain number of cycles. ARISTON DISHWASHER - Instructions for installation and use 5 D 1509)50-4 Select the right wash cycle Select the right wash cycle for your dishes. Selecting the most suitable wash cycle for the load ensures clean dishes and a more convenient use of water and electricity. A wash cycle for every degree of soil Dishwasher washing guarantees your dishes will be cleaned in a hygienic setting for safer, cleaner results. Salt, rinse aid, the right amount of detergent and the correct wash cycle: this is the formula to get the best results and to keep your dishwasher in shape. If the crockery is only lightly soiled or if it has been rinsed with water before being placed in the dishwasher, reduce the amount of detergent used accordingly. Very dirty dishes and pans (not to be used for delicate items) Super Wash Cycle for normally dirty pans and dishes. Environmentally-friendly cycle, with low energy consumption levels, suitable for normally dirty pans and dishes. Pre-wash at 40°C Wash at 63°C 2 Cold rinse Hot rinse at 67°C Drying Wash at 60° Cold rinse Hot rinse at 70°C Drying Cold pre-wash Wash at 48°C Cold rinse Hot rinse at 60°C Drying 3+24 g * * * 2:00' 27 g 1:33' Time 4 Y ou 3+24 g 2:25' Rapid & Dry Economic and fast cycle to Short wash at 48°C be used for slightly dirty Hot rinse at 67°C dishes. Preliminary wash cycle for dishes while awaiting completion of the load with the dishes from the next meal. In this case, the wash cycle time will be about 15 minutes shorter and the wash will be slightly less effective. The connection must be made to hot water supply following the same procedures as those indicated for the cold water connection. your dishwasher has arrived and moving Levelling. Once the appliance is positioned, adjust the feet by screwing them in or out depending on how high you want it and to level it so that it is horizontal. Make sure that it is not inclined more than 2 degrees. If the appliance is level, it will help ensure its correct operation. Anti-flooding protection Your dishwasher is provided with a special system which blocks the water supply in the event of leaks inside the appliance. Connect the cold water supply hose to a threaded 3/ 4 (gas) connector, and making sure that it is fastened tightly in place. If the water hoses are new or have been out of use for an extended period of time, let the water run to make sure it If the power socket to which the appliance is connected is not compatible with the plug, replace it with a suitable plug rather than using adapters or multiple plugs as these could cause overheating or burns. Fit the drain pipe into a drain line with a minimum diameter of 4 cm or place it over the sink. Use the special plastic elbow provided (see figure) to position it in the best possible way. [. . . ] When the wash cycle has ended, always remember to turn off the water supply tap and to leave the appliance door ajar. This way, moisture and bad odours will not be trapped inside. Before carrying out any cleaning or maintenance on the dishwasher, always remove the plug from the electricity socket. When you go away for an extended period of time, we recommend you do the following: • run a cycle with the dishwasher empty • turn off the water inlet tap. [. . . ]