User manual SINGER 81-50

[. . . ] That the water inlet and outlet hoses are connected correctly; 3. That the dishwasher is level on the ground. It is worth it: for the longer life span and the correct operation of your dishwasher. 13) Learn to get to know the parts which make up your dishwasher, you will use it better for it. [. . . ] Salt, rinse aid, the right amount of detergent and the correct wash cycle: this is the formula to get the best results and to keep your dishwasher in shape If the crockery is only lightly soiled or if it has been rinsed with water before being placed in the dishwasher, reduce the amount of detergent used accordingly. Select the right wash cycle for your dishes. Selecting the most suitable wash cycle for the load ensures clean dishes and a more convenient use of water and electricity. Very dirty dishes and pans (not to be used for delicate items) Super Wash Cycle for normally dirty pans and dishes. Environmentally-friendly cycle, with low energy consumption levels, suitable for normally dirty pans and dishes. pre-wash with hot water at 40°C Wash at 63°C. 2 Rinses with cold water Rinse with hot water at 67°C. Cold rinse Rinse with hot water at 70°C. Cold pre-wash Wash at 48°C Cold rinse Hot rinse at 60°C Drying 3+24 g * 2:00' 27 g * * 1:33' Daily Wash 3+24 g 2:25' Eco Rapid & Dry Economic and fast cycle to Short wash at 48°C be used for slightly dirty Hot rinse at 67°C dishes. Preliminary wash cycle for dishes while awaiting completion of the load with the dishes from the next meal. 20 g * 0:44' Short cold wash to prevent food from drying onto the dishes 0:12' Soaking ARISTON DISHWASHER - Instructions for installation and use 17 D 1509)50-4 Water in your home Loading the salt. Once the appliance is positioned, adjust the feet by screwing them in or out depending on how high you want it and to level it so that it is horizontal. Make sure that it is not inclined more than 2 degrees. If the appliance is level, it will he lp ensure its correct operation. Adjusting the Back Feet Insert the appliance into the cutout and then adjust the height using the screws located on the front bottom part of the machine. Use a screwdriver to turn the screws in the clockwise or anti-clockwise direction to increase or decrease the height respectively. Anti-flooding protection Your dishwasher is provided with a special system which blocks the water supply in the event of leaks inside the appliance. Only now can you plug the appliance into a socket provided with an efficient earth connection (the system's earthing is a guarantee of safety provided for by law, make sure your system has it). Attention - Once the appliance has been installed, the electrical plug and socket should remain accessible. - If the power supply cable is damaged, it must be replaced by the manufacturer or its Technical Assistance Service in order to prevent all potential hazards. (See Assistance) - The cable should not be bent or compressed. - The Company shall not be held responsible for any incidents that occur if these regulations are not observed. [. . . ] When the wash cycle has ended, always remember to turn off the water supply tap and to leave the appliance door ajar. This way, moisture and bad odours will not be trapped inside. Before carrying out any cleaning ormaintenanceonthedishwasher, always remove the plug from the electricity socket. Rules ensures you will always companion by your side. [. . . ]