User manual SINGER 81-56

[. . . ] That the water inlet and outlet hoses are connected correctly; 3. That the dishwasher is level on the ground. It is worth it: for the longer life span and the correct operation of your dishwasher. 13) Learn to get to know the parts which make up your dishwasher, you will use it better for it. [. . . ] In any case, please read the manufacturer's instructions on the packet. 16 ARISTON DISHWASHER - Instructions for installation and use D 1509)50-4 Select the right wash cycle A wash cycle for every degree of soil Dishwasher washing guarantees your dishes will be cleaned in a hygienic setting for safer, cleaner results. Select the right wash cycle for your dishes. Selecting the most suitable wash cycle for the load ensures clean dishes and a more convenient use of water and electricity. Salt, rinse aid, the right amount of detergent and the correct wash cycle: this is the formula to get the best results and to keep your dishwasher in shape. If the crockery is only lightly soiled or if it has been rinsed with water before being placed in the dishwasher, reduce the amount of detergent used accordingly. Intensive Wash Very dirty dishes and pans (not to be used for delicate items) Pre-wash with hot water at 40°C Wash at 63°C 2 Rinses with cold water Rinse with hot water at 67°C Drying 3+24 gr. * 2:00' Cycle for normally dirty pans and dishes. Daily Wash Preliminary wash cycle for dishes while awaiting completion of the load with the dishes from the next meal. Environmentally-friendly cycle, with low energy consumption levels, suitable for normally dirty pans and dishes. Wash at 60° Cold rinse Rinse with hot water at 70°C Drying 27 gr. If the appliance is level, it will he lp ensure its correct operation. Adjusting the Back Feet Insert the appliance into the cutout and then adjust the height using the screws located on the front bottom part of the machine. Use a screwdriver to turn the screws in the clockwise or anti-clockwise direction to increase or decrease the height respectively. Anti-flooding protection Your dishwasher is provided with a special system which blocks the water supply in Cold water connection. Connect the cold water supply hose to a threaded 3/ 4 (gas) connector, and making sure that it is fastened tightly in place. If the water hoses are new or have been out of use for an extended period of time, let the water run to make sure it is clear and free of impurities before making the connection. If this precaution is not taken, the water inlet could get blocked, causing damage to your dishwasher. The appliance must be connected to the water supply network using new piping. Your dishwasher can be supplied with hot water from the mains supply (if you have a central heating system with radiators) at a temperature of no more than 60°C. In this case, the wash cycle time will be about 15 minutes shorter and the wash will be slightly less effective. The connection must be made to hot water supply following the same procedures as those indicated for the cold water connection. [. . . ] When the wash cycle has ended, always remember to turn off the water supply tap and to leave the appliance door ajar. This way, moisture and bad odours will not be trapped inside. Before carrying out any cleaning ormaintenanceonthedishwasher, always remove the plug from the electricity socket. Rules ensures you will always companion by your side. [. . . ]