User manual SINGER 81-65

[. . . ] Present in the water do not clog the appliance; after performing this operation, screw the inlet hose tightly onto a tap with a ¾ gas threaded connection. €¢ To a suitable hot water connection point: your dishwasher may be provided with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply.  If the inlet hose is not long enough, contact a specialist store or an authorised technician (see Assistance ). [. . . ] Select the wash cycle and press the START/RESET button: after the beep sounds, the timer begins counting down. Once this time has elapsed, the indicator light switches off and the wash cycle begins. To adjust the delay time and select a smaller period of time, press the DELAYED START button. To cancel it, press the button repeatedly until the wash cycle begins and the WASH CYCLE PHASE indicator light corresponding to the start of the cycle in progress illuminates. Recap Settings Press the SELECT WASH CYCLE button: The indicator light corresponding to the wash cycle selected will illuminate, followed by the HALF LOAD* indicator light or the ALL-IN-ONE TABLETS* indicator light (if these options have been selected). Adding extra crockery Press the ON/OFF button and open the door, taking care to avoid the escaping steam, and place the crockery inside the dishwasher. Press the ON/OFF button again: the cycle starts from the point at which it was interrupted. This option optimises the results of the wash. The overall duration of the programme increases by approximately 10 minutes. This option is not recommended for use with wash cycles which do not specify the use of multi-use tablets (see table of wash cycles). Accidental interruptions If the door is opened during the wash cycle, or if there is a power cut, the cycle stops. ) fill the salt dispenser and set the adjuster to -; if the hardness of the water is greater than 60°fH, set it to +. 20 Care and maintenance Shutting off the water and electricity supplies • Turn off the water tap after every wash cycle to avoid leaks. €¢ Remove the plug from the socket when cleaning the machine and when carrying out maintenance work. Cleaning the filters The filters remove food residue from the water used in the wash cycle: to obtain the best results from each wash, they should be cleaned.  The dishwasher should not be used without filters, or when the filter is loose. Remove the filters by pulling the handle upwards. Clean the filters: • after every wash cycle, remove the largest pieces of residue from semicircular plate A and glass B (these may be removed by pulling the handle) by rinsing them under running water. EN Cleaning the dishwasher • The external surfaces of the machine and the control panel may be cleaned using a nonabrasive cloth which has been dampened with water. do not use solvents or abrasive products. €¢ Any marks on the appliance interior may be removed using a cloth dampened with water and a little vinegar. C 1 2 Preventing unpleasant odours • Always keep the door of the appliance ajar in order to avoid moisture from forming and being trapped inside the machine. [. . . ] • The rinse aid has been used up or the dosage is too low (see Rinse aid and salt). ╠The rinse aid dispenser setting is not high enough. • A wash cycle without a drying programme has been selected. • The racks are overloaded (see Loading the racks). [. . . ]