User manual SINGER 81-77

[. . . ] €¢ To a suitable hot water connection point: your dishwasher may be provided with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply.  If the inlet hose is not long enough, contact a specialist store or an authorised technician (see Assistance ).  The water pressure must be within the values indicated in the Technical data table (see below). [. . . ] After one long beep and three short beeps, the WASH CYCLE indicator light will switch off: select the new wash cycle and start the programme by shutting the door. Adding extra crockery Open the door, taking care to avoid the escaping steam, and place the crockery inside the dishwasher. Close the door: the cycle starts from the point at which it was interrupted. Accidental interruptions If the door is opened during the wash cycle, or if there is a power cut, the cycle stops. It starts again from the point at which it was interrupted once the door has been shut or the electricity supply is restored. Loading the detergent A successful wash also depends on the correct amount of detergent being used, as recommended by the manufacturer. Exceeding the recommended amount does not result in a more effective wash and pollutes the environment.  To obtain the best results from each washing and drying cycle, powder detergent, rinse aid liquid and salt should be used. Pour in the detergent after consulting the Wash cycle table: • for powder detergent use compartments A and B • for tablets, use compartment A and the bottom of the appliance, C i. When the cycle requires 1 tablet, place it in compartment A and close the cover; when it requires 2, place the second tablet at the bottom of the appliance. Remove detergent residues from the edges of the compartment and close the cover until it clicks. €¢ when the LOW RINSE AID* indicator light on the panel flashes; 1. Open the dispenser by turning the lid (G) in an H anticlockwise direction. Pour in the rinse aid, making sure it does not overflow from the F dispenser. If this happens, G clean the spill immediately with a sponge. NEVER pour the rinse aid directly into the appliance tub. do not use solvents or abrasive products. €¢ Any marks on the appliance interior may be removed using a cloth dampened with water and a little vinegar. C 1 2 Preventing unpleasant odours • Always keep the door of the appliance ajar in order to avoid moisture from forming and being trapped inside the machine. €¢ Clean the seals around the door and detergent dispensers regularly using a damp sponge. This will avoid food becoming trapped in the seals, which is the main cause of the formation of unpleasant odours. A B Cleaning the sprayer arms Food residue may become encrusted onto the sprayer arms and block the holes used to spray the water. [. . . ] The dishes and glasses are covered in a white film or limescale deposits. Possible causes / Solutions: • The plug has no t bee n inser te d in to the elec trical sock et properly , or th ere is no powe r in the hou se. • The dishwa sher door has not been shut pro perly. • The dishes are ra ttlin g again st each o the r o r a gain s t the s pray er a rm s . [. . . ]