User manual SINGER 81-78

[. . . ] €¢ To a suitable hot water connection point: your dishwasher may be provided with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply.  If the inlet hose is not long enough, contact a specialist store or an authorised technician (see Assistance ).  The water pressure must be within the values indicated in the Technical data table (see below). [. . . ] Unload the racks, beginning with the lower level. Modifying a wash cycle in progress If a mistake was made during the wash cycle selection process it is possible to change the cycle, provided that it has only just begun: open the door, taking care to avoid the escaping steam, and press the WASH CYCLE SELECT button, holding it for 4 seconds. After one long beep and three short beeps, the WASH CYCLE indicator light will switch off: select the new wash cycle and start the programme by shutting the door. Adding extra crockery Open the door, taking care to avoid the escaping steam, and place the crockery inside the dishwasher. Close the door: the cycle starts from the point at which it was interrupted. Accidental interruptions If the door is opened during the wash cycle, or if there is a power cut, the cycle stops. It starts again from the point at which it was interrupted once the door has been shut or the electricity supply is restored. Loading the detergent A successful wash also depends on the correct amount of detergent being used, as recommended by the manufacturer. Exceeding the recommended amount does not result in a more effective wash and pollutes the environment.  To obtain the best results from each washing and drying cycle, powder detergent, rinse aid liquid and salt should be used. Pour in the detergent after consulting the Wash cycle table: • for powder detergent use compartments A and B • for tablets, use compartment A and the bottom of the appliance, C i. Open the dispenser by turning the lid (G) in an H anticlockwise direction. Pour in the rinse aid, making sure it does not overflow from the F dispenser. If this happens, G clean the spill immediately with a sponge. NEVER pour the rinse aid directly into the appliance tub. Adjusting the amount of rinse aid If you are not completely satisfied with the washing or drying results, you may adjust the quantity of rinse aid used. Use a screwdriver to turn the dosage adjuster to one of the 6 pre-set positions (the default position is set to 4): • if there are bluish streaks on the crockery, set the adjuster to a lower number (1-3). €¢ Clean the seals around the door and detergent dispensers regularly using a damp sponge. This will avoid food becoming trapped in the seals, which is the main cause of the formation of unpleasant odours. A B Cleaning the sprayer arms Food residue may become encrusted onto the sprayer arms and block the holes used to spray the water. It is therefore recommended that the arms are checked from time to time and cleaned with a small non-metallic brush. €¢ The entire filter assembly should be cleaned thoroughly C B once a month: this includes the semicircular plate A, A the glass B and the cylinder C (this may be removed by turning it in an anti-clockwise direction). [. . . ] The dishes and glasses are covered in a white film or limescale deposits. Possible causes / Solutions: • The plug has no t bee n inser te d in to the elec trical sock et properly , or th ere is no powe r in the hou se. • The dishwa sher door has not been shut pro perly. • The dishes are ra ttlin g again st each o the r o r a gain s t the s pray er a rm s . [. . . ]