User manual SINGER 821K70

[. . . ] Present in the water do not clog the appliance; after performing this operation, screw the inlet hose tightly onto a tap with a ¾ gas threaded connection. € To a suitable hot water connection point: your dishwasher may be provided with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply.  If the inlet hose is not long enough, contact a specialist store or an authorised technician (see Assistance ). [. . . ] The overall duration of the programme increases by approximately 10 minutes.  This option is not recommended for use with wash cycles which do not specify the use of multi-use tablets (see table of wash cycles). Accidental interruptions If the door is opened during the wash cycle, or if there is a power cut, the cycle stops. It starts again from the point at which it was interrupted once the door has been shut or the electricity supply is restored. Loading the detergent A successful wash also depends on the correct amount of detergent being used, as recommended by the manufacturer. Exceeding the recommended amount does not result in a more effective wash and pollutes the environment.  To obtain the best results from each washing and drying cycle, powder detergent, rinse aid liquid and salt should be used. 6 Wash cycles Wash cycle table  Ariston dishwashers are fitted with an automatic filter cleaning system that may increase the cycle duration.  The number and type of wash cycles varies according to the model of dishwasher.  If the crockery is only lightly soiled or if it has been rinsed with water before being placed in the dishwasher, reduce the amount of detergent used accordingly. Normal Environmentally-friendly wash cycle with low energy consumption levels, suitable for pans and dishes. Cleaning the filters The filters remove food residue from the water used in the wash cycle: to obtain the best results from each wash, they should be cleaned.  The dishwasher should not be used without filters or when the filter is loose. Remove the filters by pulling the handle upwards. Clean the filters: • after every wash cycle, remove the largest pieces of residue from semicircular plate A and glass B (these may be removed by pulling the handle) by rinsing them under running water. EN Cleaning the dishwasher • The external surfaces of the machine and the control panel may be cleaned using a nonabrasive cloth which has been dampened with water. do not use solvents or abrasive products. € Any marks on the appliance interior may be removed using a cloth dampened with water and a little vinegar. C 1 2 Preventing unpleasant odours • Always keep the door of the appliance ajar in order to avoid moisture from forming and being trapped inside the machine. € Clean the seals around the door and detergent dispensers regularly using a damp sponge. This will avoid food becoming trapped in the seals, which is the main cause of the formation of unpleasant odours. A B Cleaning the sprayer arms Food residue may become encrusted onto the sprayer arms and block the holes used to spray the water. [. . . ] Reprogramme the machine and restart the wash cycle. • Switch off the machine by pressing the ON/OFF button and clean the filters (see Maintenance), then switch the dishwasher back on by pressing the same button. Reprogramme the machine and restart the wash cycle. • Switch off the ap pliance by pressing the ON/OFF button and switch it back on after a minute. [. . . ]