User manual SINGER 86K61

[. . . ] €¢ To a suitable hot water connection point: your dishwasher may be provided with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply.  If the inlet hose is not long enough, contact a specialist store or an authorised technician (see Assistance ).  The water pressure must be within the values indicated in the Technical data table (see below). [. . . ] Press the ON/OFF button again: the cycle starts from the point at which it was interrupted. Accidental interruptions If the door is opened during the wash cycle, or if there is a power cut, the cycle stops. It starts again from the point at which it was interrupted once the door has been shut or the electricity supply is restored. Loading the detergent A successful wash also depends on the correct amount of detergent being used, as recommended by the manufacturer. Exceeding the recommended amount does not result in a more effective wash and pollutes the environment.  To obtain the best results from each washing and drying cycle, powder detergent, rinse aid liquid and salt should be used. Pour in the detergent after consulting the Wash cycle table: • for powder detergent use compartments A and B • for tablets, use compartment A and the bottom of the appliance, C i. When the cycle requires 1 tablet, place it in compartment A and close the cover; when it requires 2, place the second tablet at the bottom of the appliance. Remove detergent residues from the edges of the compartment and close the cover until it clicks. D Washing options Extra drying* To make sure that the crockery is completely dry at the end of the cycle, press the EXTRA DRYING button before selecting the wash cycle. A prolonged beep will sound to indicate that this option has been selected and a short beep will sound to indicate when it has been deselected.  The dishwasher should not be used without filters.  The dishwasher should not be used without filters, or when the filter is loose. Remove the filters by pulling the handle upwards. Clean the filters: • after every wash cycle, remove the largest pieces of residue from semicircular plate A and glass B (these may be removed by pulling the handle) by rinsing them under EN Cleaning the dishwasher • The external surfaces of the machine and the control panel may be cleaned using a nonabrasive cloth which has been dampened with water. do not use solvents or abrasive products. €¢ Any marks on the appliance interior may be removed using a cloth dampened with water and a little vinegar. C 1 2 Preventing unpleasant odours • Always keep the door of the appliance ajar in order to avoid moisture from forming and being trapped inside the machine. €¢ Clean the seals around the door and detergent dispensers regularly using a damp sponge. This will avoid food becoming trapped in the seals, which is the main cause of the formation of unpleasant odours. €¢ The entire filter assembly should be C B cleaned thoroughly once a month: this includes the A semicircular plate A, the glass B and the cylinder C (this may be removed by turning it in an anti-clockwise direction). Use a small non-metallic brush to clean these parts. [. . . ] • The rinse aid has been used up or the dosage is too low (see Rinse aid and salt). ╠The rinse aid dispenser setting is not high enough. • A wash cycle without a drying programme has been selected. • The racks are overloaded (see Loading the racks). [. . . ]