User manual SINGER 96-87

[. . . ] If the appliance must be moved at any time, keep it in an upright position; if absolutely necessary, it may be tilted onto its back. €¢ To a suitable hot water connection point: your dishwasher may be provided with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply. If the inlet hose is not long enough, contact a specialist store or an authorised technician (see Assistance ). [. . . ] Press the SELECT button to select the desired delay period. Select the wash cycle by pressing the SELECT WASH CYCLE button. Press the START/RESET button: after the beep sounds, the timer begins counting down. Once this time has elapsed, the indicator light switches off and the wash cycle begins. To modify the delay and select a shorter period of time, press the MODE and SELECT buttons to repeat the selection process. To cancel it, press the SELECT button repeatedly until OFF appears on the display, the DELAYED START symbol switches off, the wash cycle begins and the WASH CYCLE PHASE indicator light corresponding to the start of the cycle in progress illuminates. Half load using the upper or lower rack If there are not many dishes to be washed, a half load cycle may be used in order to save water, electricity and detergent. Press the MODE button until the HALF LOAD symbol has been selected. Press the SELECT button, select upper half loading, lower half loading or OFF (no selection). Select the wash cycle by pressing the SELECT WASH CYCLE button. Press the START/RESET button; a beep will indicate that the wash cycle has started. €¢ when the LOW RINSE AID* indicator light on the panel flashes; 1. Open the dispenser by turning the lid (G) in an H anticlockwise direction. Pour in the rinse aid, making sure it does not overflow from the F dispenser. If this happens, G clean the spill immediately with a sponge. Adjusting the amount of rinse aid If you are not completely satisfied with the washing or drying results, you may adjust the quantity of rinse aid used. Use a screwdriver to turn the dosage adjuster to one of the 6 pre-set positions (the default position is set to 4): • if there are white streaks on the crockery, set the adjuster to a lower number (1-3). €¢ if drops of water remain on the crockery or there are limescale marks present after the cycle has finished, set the adjuster to a higher number (4-6). If you are using multi-functional tablets (2-in-1, 3-in-1, 4-in-1, etc. ) and you wish to further improve the drying performance of the appliance, fill the dispenser and set the dosage adjuster to 2. Loading the refined salt In order to obtain the best possible results from a wash cycle, make sure that the dispenser is never empty. Refined salt removes limescale from the water, thus avoiding the formation of deposits on crockery. [. . . ] €¢ The rinse aid has been used up or the dosage is too low. €¢ The rinse aid has been used up or the dosage is too low ( see Rinse aid and salt ). • The rinse aid dispenser setting is not high enough. €¢ A wash cycle without a drying programme has been selected. [. . . ]