User manual SINGER 99W130

[. . . ] If the appliance must be moved at any time, keep it in an upright position; if absolutely necessary, it may be tilted onto its back. Connecting the water inlet hose • To a suitable cold water connection point: before attaching the hose, run the water until it is perfectly clear so that any impurities that may be present in the water do not clog the appliance; after performing this operation, screw the inlet hose tightly onto a tap with a ¾ gas threaded connection. €¢ To a suitable hot water connection point: your dishwasher may be provided with hot water from the mains supply (if you have a central heating system with radiators) provided that it does not exceed a temperature of 60°C. Screw the hose to the tap as described for connection to a cold water supply. [. . . ] Turn the SELECT WASH CYCLE knob in an anticlockwise direction until it reaches the RESET position, so that all the settings are reset. Switch off the appliance by pressing the ON/OFF button, shut off the water valve and unplug the appliance from the electricity socket. Open the door and wait for a few minutes before removing the crockery inside, in order to avoid burns. Unload the racks, beginning with the lower level. Modifying the wash cycle in progress If you have made an error in the selection process, it may be rectified within one minute of the start of the cycle: turn the SELECT WASH CYCLE knob in an anticlockwise direction until it reaches the RESET position and after a few seconds the WASH CYCLE PHASE indicator light will switch off. Adding extra crockery Open the door, taking care to avoid the escaping steam, and place the crockery inside the dishwasher. Close the door: the cycle starts from the point at which it was interrupted. Accidental interruptions If the door is opened during the wash cycle, or if there is a power cut, the cycle stops. It starts again from the point at which it was interrupted once the door has been shut or the electricity supply is restored. Loading the detergent A successful wash also depends on the correct amount of detergent being used, as recommended by the manufacturer. Exceeding the recommended amount does not result in a more effective wash and pollutes the environment. €¢ Remove the plug from the socket when cleaning the machine and when carrying out maintenance work. Cleaning the filters The filters remove food residue from the water used in the wash cycle: to obtain the best results from each wash, they should be cleaned. After cleaning check that the filter assembly has been replaced correctly. The dishwasher should not be used without filters. Remove the filters by pulling the handle upwards. Clean the filters: • after every wash cycle, remove the largest pieces of residue from semicircular plate A and glass B (these may be removed by pulling the handle) by rinsing them under running water. EN Cleaning the dishwasher • The external surfaces of the machine and the control panel may be cleaned using a cloth dampened with warm soapy water. do not use solvents or abrasive products. €¢ Any marks on the appliance interior may be removed using a cloth dampened with water and a little vinegar. C 1 2 A B Preventing unpleasant odours • Always keep the door of the appliance ajar in order to avoid moisture from forming and being trapped inside the machine. €¢ Clean the seals around the door and detergent dispensers regularly using a damp sponge. [. . . ] €¢ The dishes are rattling against each other or against the sprayer arms. €¢ The level of the refined salt is low or the dosage setting is not suited to the hardness of the water ( see Rinse aid and salt ). €¢ The lid on the salt dispenser is not closed properly. €¢ The rinse aid has been used up or the dosage is too low. [. . . ]