User manual SINGER CONFIDENCE 7467

[. . . ] Please note that the actual controls and components, menu items, etc. of your High Definition Video Camera may look somewhat different from those shown in the illustrations in these Operating Instructions. Before use Remove the connector cover. How to replace the fuse The location of the fuse differ according to the type of AC mains plug (figures A and B). Confirm the AC mains plug fitted and follow the instructions below. Illustrations may differ from actual AC mains plug. [. . . ] ≥ All enquiries transactions and distribution facilities are provided directly by Panasonic UK. ≥ Also available through our Internet is direct shopping for a wide range of finished products. Take a browse on our website for further details. 8 VQT4Q81 HC-V720&V720M&V710EP&EB_VQT4Q81_mst. book 9 ページ ２０１２年１２月２０日　木曜日　午後２時０分 Accessories Check the accessories before using this unit. Please be advised that we are not liable for any accident or failure occurring as a result of use of a counterfeit battery pack. To ensure that safe products are used we would recommend that a genuine Panasonic battery pack is used. Inserting/removing the battery ≥ Press the power button to turn off the unit. (l 14) Install the battery by inserting it in the direction shown in the figure. Removing the battery Be sure to hold down the power button until the status indicator goes off. Then remove the battery while supporting the unit to prevent it from dropping. Move the battery release lever in the direction indicated by the arrow and remove the battery when unlocked. A Battery holder Insert the battery until it clicks and locks. 10 VQT4Q81 HC-V720&V720M&V710EP&EB_VQT4Q81_mst. book 11 ページ ２０１２年１２月２０日　木曜日　午後２時０分 Charging the battery When this unit is purchased, the battery is not charged. Charge the battery fully before using this unit for the first time. The unit is in the standby condition when the AC adaptor is connected. The primary circuit is always “live” as long as the AC adaptor is connected to an electrical outlet. Caution: Check that the access lamp has gone off. Access lamp [ACCESS] A    ≥ When this unit is accessing the SD card or built-in memory, the access lamp lights up. 1 Open the SD card cover and insert (remove) the SD card into (from) the card slot B. ≥ Face the label side C in the direction shown in the illustration and press it straight in as far as it will go. ≥ Press the centre of the SD card and then pull it straight out. 2 Securely close the SD card cover. ≥ Securely close it until it clicks. VQT4Q81 13 HC-V720&V720M&V710EP&EB_VQT4Q81_mst. book 14 ページ ２０１２年１２月２０日　木曜日　午後２時０分 Preparation Turning the unit on/off You can turn the unit on and off using the power button or by opening and closing the LCD monitor. Turning the unit on and off with the power button Open the LCD monitor and press the power button to turn on the unit.  To turn off the unit Hold down the power button until the status indicator goes off. A The status indicator lights on. The unit is turned on when the LCD monitor is opened, and unit is turned off when it is closed. Preparation How to use the touch screen You can operate by directly touching the LCD monitor (touch screen) with your finger. ∫ Touch Touch and release the touch screen to select icon or picture. ≥ Touching the touch screen will not operate while you are touching another part of the touch screen. ∫ Slide while touching Move your finger while pressing on the touch screen. 14 VQT4Q81 HC-V720&V720M&V710EP&EB_VQT4Q81_mst. book 15 ページ ２０１２年１２月２０日　木曜日　午後２時０分 ∫ About the operation icons / / / : Touch when changing a page or performing settings. : Touch to return to the previous screen. About the Touch Menu Touch (left side)/ (right side) of on the Touch Menu to switch the operation icons. ≥ It is also possible to switch the operation icons by  sliding the Touch Menu right or left while touching it. T W A Touch Menu ∫ To display the Touch Menu Display of the Touch Menu will disappear when no touch operation is performed for a specific period of time during recording of motion picture/still picture. To display it again, touch . VQT4Q81 15 HC-V720&V720M&V710EP&EB_VQT4Q81_mst. book 16 ページ ２０１２年１２月２０日　木曜日　午後２時０分 Preparation Setting date and time The clock is not set at the time of purchase. Make sure to set the clock. 1 2 A Select the menu. (l 21) : [SETUP] # [CLOCK SET] MENU Touch the date or time to be set, then set the desired value using / . 3 Displaying the World Time setting: [HOME]/ [DESTINATION] ≥ The year can be set between 2000 and 2039. Touch [ENTER]. ≥ A message prompting for World Time setting may be displayed. Perform the World Time setting by touching the screen. ≥ Touch [EXIT] to complete the setting. ≥ HC-V720 / HC-V727 / HC-V720M At the time of purchase, the confirmation screen for the Wi-Fi setup is displayed after setting the world time. Exit the screen if the setup is not necessary. [. . . ] 3 lx (1/25 with Low Light Mode in the Scene Mode) Approx. 1 lx with the Colour Night View function AV connector video output level: 1. 0 Vp-p, 75 h, PAL system HDMI mini connector video output level: HDMI™ (x. v. Colour™) 1080p/1080i/576p AV connector audio output level (Line): 316 mV, 600 h, 2 ch HDMI mini connector audio output level: [AVCHD]; Dolby Digital/Linear PCM [iFrame], [MP4]; Linear PCM MIC input: j60 dBV (Mic sensitivity j40 dB equivalent, 0 dB=1 V/Pa, 1 kHz) (Stereo mini jack) USB: Reader function SD card; Read only (No copyright protection support) HC-V720M Built-in memory; Read only Hi-Speed USB (USB 2. 0), USB terminal Type Mini AB USB host function (for USB HDD) Battery charging function (Charges from USB terminal when the main unit is off) Flash: Available range; Approx. 1. 5 m or less Dimensions: 60. 1 mm (W)k69. 3 mm (H)k124. 4 mm (D) (including projecting parts) Mass: HC-V720 / HC-V727 Approx. 277 g [without battery (supplied) and an SD card (optional)] HC-V720M Approx. [. . . ]