User manual SINGER DECORATIVE 042300DECO

[. . . ] To disconnect, turn all controls to the off ("O") position, then remove plug from outlet. To unplug, grasp the plug, not the cord. The sound pressure level under normal operating conditions is 75dB(A). Please turn off the machine or unplug when the machine is not operating properly. [. . . ] If the tension is too loose, it will drop too much. To adjust, turn the small screw on the side of the bobbin case. please note: - Proper setting of tension is important to good sewing. - There is no single tension setting appropriate for all stitch functions, thread or fabric. - A balanced tension (identical stitches both top and bottom) is usually only desirable for straight stitch construction sewing. - 90% of all sewing will be between "3" and "5". - For zig zag and decorative sewing stitch functions, thread tension should generally be less than for straight stitch sewing. - For all decorative sewing you will always obtain a nicer stitch and less fabric puckering when the upper thread appears on the bottom side of your fabric. 16 6 4 3 2 1 EN Threading the Upper Thread This is a simple operation but it is important to carry out correctly as by not doing so several sewing problems could result. - Start by raising the needle to its highest point (1), and continue turning the handwheel counterclockwise until the needle just slightly begins to descend. Raise the presser foot to release the tension discs. (1) Turn the Stitch Length Dial, and the length of the individual stitches will decrease as the dial approached "0". The length of the individual stitches will increase as the dial approaches "4". (2) Generally speaking, use a longer stitch length when sewing heavier weight fabrics or when using a thicker needle or thread. Use a shorter stitch length when sewing lighter weight fabrics or when using a finer needle or thread. 5 1 2 3 4 1 2 Function of stitch length dial while zig-zag stitching Turn the Pattern Selector Dial to " ". 24 EN Sewing Straight Stitch To begin sewing, set the machine for straight stitch in either center or right needle position. (1) 1 Place the fabric under the presser foot with the fabric edge lined up with the desired seam guide line on the needle plate. (2) Lower the presser foot lifter, and then step on the foot controller to start sewing. 26 EN Reverse Sewing A To secure the beginning and the end of a seam, press down the reverse sewing lever (A). Release the lever and the machine will sew forward again. (1) Removing the Work Turn the handwheel toward you (counterclockwise) to bring the thread take up lever to its highest position, raise the presser foot and remove work behind the needle and presser foot. [. . . ] 9 ) 45 EN Inserting & Changing Needles D A Change the needle regularly, especially if it is showing signs of wear and causing problems. For best sewing results always use SINGER Brand Needles. insert the needle as illustrated as follows: A. Loosen the needle clamp screw and tighten again after inserting the new needle. [. . . ]