User manual SITECOM WLX-2002

[. . . ] WLX-2002 Introduction Thank you for purchasing the Sitecom WLX-2002 Wi-Fi Access Point N300. It complies with wireless 802. 11b/g/n standards and can create a Wi-Fi network with data transmission rates of up to 300Mbps. With the WLX-2002, you can enjoy high-speed wireless networking throughout your home without additional cabling. The WLX-2000 features a WPS button which allows you to connect to the access point with a simple click of a button. [. . . ] Select wireless channel width (bandwidth taken by wireless signals of this access point). It’s suggested to select ‘Auto 20/40MHz’. Do not change to ’20 MHz’ unless you know what it is. Set the type of preamble of wireless radio. The default setting is ‘Short Preamble’. Decide if the wireless access point will broadcast its own ESSID or not. You can hide the ESSID of your wireless access point (set the option to ‘Disable’), so only people who know the ESSID of your wireless access point can get connected. WMM (Wi-Fi Multimedia) technology, which can improve the performance of certain network applications, like audio/video streaming, network telephony (VoIP), and others. You can fill-in the PIN code of the wireless device and press the button to start the WPS process. The router will wait for the WPS request from the wireless device within 2 minutes. Self Pin Code SSID Authentication Mode Passphrase Key Mode WPS via Push Button WPS via PIN 13 TOOLBOX SETTINGS System This device provides some control functions including password, IP address management, and DHCP server function. Please go to Toolbox, and open the ‘System’ tab, to access these functions. Below are detailed descriptions of every control function. Password Settings You can change the password used to enter the web configuration menu of this device. Please input the current password in the ‘Current Password’ field, then input a new password in both the ‘New Password’ and the ‘Re-Enter Password’ field. After you finish, please go to the bottom of the page and click ‘Apply’. IP Management You can change the IP address of this device, so it can become a part of your local network. Please remember this address or you will not be able to connect the configuration menu of device. The default IP address is: 192. 168. 128. 253 / Subnet Mask 255. 255. 255. 0. If you want to activate the DHCP server function of this device, please select ‘Enabled’ in the ‘DHCP Server’ option, and see the next Section for detailed instructions. If you don’t want to use the DHCP server function of this device, or there’s another DHCP server on the network this device connects to, please select ‘Disable’. After you finish, please go to the bottom of this page and click ‘Apply’. DHCP Server DHCP Server This device is capable to act as a DHCP server for your network. Default Gateway DNS Address DHCP Client Start Address Please input the IP address of default gateway of your network here. Please input the IP address of domain name server (DNS) here. [. . . ] You are not responsible for enforcing compliance by third parties to this License. If, as a consequence of a court judgment or allegation of patent infringement or for any other reason (not limited to patent issues), conditions are imposed on you (whether by court order, agreement or otherwise) that contradict the conditions of this License, they do not excuse you from the conditions of this License. If you cannot distribute so as to satisfy simultaneously your obligations under this License and any other pertinent obligations, then as a consequence you may not distribute the Program at all. For example, if a patent license would not permit royalty-free redistribution of the Program by all those who receive copies directly or indirectly through you, then the only way you could satisfy both it and this License would be to refrain entirely from distribution of the Program. [. . . ]