User manual SKIL 3115

[. . . ] Tie back long hair or wear protective hair covering and roll long sleeves above the elbow. Rubber gloves and non-skid footwear are recommended when working outdoors. uSE SAFETY GOGGLES Use safety goggles (head protection). Wear safety goggles (must comply with ANSI Standard Z87. [. . . ] Any alteration or modification not specified is misuse and may result in dangerous conditions. Motors in these tools normally spark, and may result in a dangerous condition. MAINTAIN TOOLS WITH CARE Keep tools sharp and clean for better and safer performance. Keep handles dry, clean and free from oil and grease. WARNING sawing, grinding, drilling, and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: · lead from lead-based paints , · Crystalline silica from bricks and cement and other masonry products, and · Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles. This product contains a chemical known to the ! wARNING State of California to cause cancer. Place the working stand on a solid, flat and level surface. When the working stand can shift or rock, the power tool or work piece cannot be steadily and safely controlled. Do not overload the working stand or use as ladder or scaffolding. Overloading or standing on the working stand cause the stand to be "top-heavy" and likely to tip over. Read and understand all instructions for use of Xbench. Failure to follow all instructions listed below may result in serious personal injury. the stamped rails or clamps may have sharp edges. Be careful in handling the bench to prevent being cut. fully assemble and tighten all the fasteners required for this stand. Also remember to occasionally check the stand and make sure it is still tight. A loose stand is unstable and may shift in use and cause serious injury. Before operating make sure the entire unit is placed on a solid, flat, level surface. Serious injury could occur if tool is unstable and tips. [. . . ] To unfold bench, pull up rear while pushing down in front. Ensure hinged support arm is locked (Fig. To fold bench, push up on hinged support arm, then pull up on front of bench while pushing down on the rear (Fig. Some of these are: Avoiding use of these and other types of cleaning agents will minimize the possibility of damage. [. . . ]