User manual SKIL 3305-01

[. . . ] WARNING "READ ALL INSTRUCTIONS" Failure to follow the safety rules listed below and other basic safety precautions may result in serious personal injury. All visitors should be kept away from work area. CHECK DAMAGED PARTS Before further use of the tool, a guard or other part that is damaged should be carefully checked to ensure that it will operate properly and perform its intended function. Check for alignment of moving parts, mounting and any other conditions that may affect its operation. [. . . ] Reach under the front and rear of the table with a wrench to access these nuts (Fig. If additional adjustment is required, loosen only the two front adjustment nuts 6 and repeat steps 4 & 5 until the blade is parallel to the miter slot. Tighten the two front adjustment nuts 6 (Fig. Stand the saw on its left side and tighten the four center adjustment nuts 8 (Fig. Place the saw upright and re-check the alignment to make sure the blade is parallel to the miter slot. Disconnect plug from power source before performing any assembly, adjustment or repair to avoid possible injury. NOTE: Clean blade of any excess oil before installation. Raise the blade 3 to the maximum height by turning the control wheel 4 counterclockwise (Fig. Clean any sawdust from both blade collars before installing the blade. Install the saw blade onto the the arbor with the blade teeth pointing toward the front of the saw. To avoid injury, do not use a blade larger or smaller than 10" diameter and 5/8" arbor. To tighten the arbor nut 5, use the open-end wrench 7 and align the wrench jaws on the flats of the flange to keep the arbor from turning. Place the box-end wrench 8 on the arbor nut 5 and turn clockwise (to the rear of the saw table) (Fig. To avoid injury from a thrown workpiece, blade part, or blade contact, never operate the saw without the proper insert in place. Use the dado insert when using a dado blade. Carbide is very brittle and can be easily damaged. Use caution when you install, use or store the blades. Do not use a carbide-tipped blade that is bent or has bent teeth, or if the blade has cracks, is broken, or has missing/loose carbide tips. Do not operate a carbide-tipped blade faster than its recommended speed. Read, understand and follow all warnings and instructions provided with your carbide-tipped blades. The rip fence must be parallel with the SAWBLADE in order to prevent KICKBACK when ripping. Your table saw is equipped with a Self-Aligning, Quick-Set rip fence. [. . . ] contact the nearest Factory Service Center or Authorized Service Station or other competent repair service. Use only identical replacement parts, any other may create a hazard. After five hours of operation, the blade elevation/tilting mechanism should be checked for looseness, binding, or other abnormalities. Disconnect the saw from the power source, turn the saw upside down and pull up and down on the motor unit. [. . . ]