User manual SKIL 3310

[. . . ] WARNING "READ ALL INSTRUCTIONS" Failure to follow the safety rules listed below and other basic safety precautions may result in serious personal injury. All visitors should be kept away from work area. AVOID ACCIDENTAL STARTING Make sure the switch is in the "OFF" position before plugging in tool. nEVER STAND ON TOOL OR ITS STAND Serious injury could occur if the tool is tipped or if the cutting tool is accidentally contacted. [. . . ] NOTE: Mount the table saw to the leg stand using the hardware supplied in the hardware kit. Place the table saw onto the assembled leg stand so that the four (4) mounting holes 4 in the base of the saw are over the four (4) mounting holes in the front and rear top plates 5 (Fig. Secure the table saw to the leg stand using four (4) bolts 6, washers 7, and lock nuts 8. When mounting the table saw to the leg stand, DO NOT overtighten the mounting hardware. Before operating table saw, securely fasten !WARNING table saw to stand and entire unit must be placed on solid, level surface. WARNING Do not stand on table saw sand or use as ladder or scaffolding. Do not use table saw if stand tips, slides, or moves in any way. If table saw is to be used in a permanent location, it should be fastened securely to a firm supporting surface such as a stand or workbench, using the four mounting holes, 1 two of which are shown (Fig. When mounting table saw to a workbench or plywood, holes should be drilled through the supporting surface of the workbench or plywood and a opening MUST be made the same size as the opening in the bottom of the saw using the dimensions illustrated (Fig. Each of the four mounting holes should be bolted securely using 5/16" hex nuts (not included). Screw lengths should be 2-1/2" longer than the thickness of the bench top. Locate and mark where the saw is to be mounted. Place table saw on workbench aligning holes in base with holes drilled in workbench. An alternative method of securing your table saw is to fasten the saw base to a mounting board 24" x 24" minimum size to prevent saw from tipping while in use. Any good grade of plywood with a 3/4" minimum thickness is recommended. Follow instructions for mounting to workbench, substituting a plywood board 24" x 24" minimum size and using 5/16" flat head machine screws, flat washers, and hex nuts (not included). Screw length must be at least 2-1/2" more than the thickness of the mounting board. Insert screws up through mounting board and through base holes. place flat washers on stud and secure with hex nuts. NOTE: For proper stability, holes must be counter sunk on bottom side of plywood so screw heads are flush with the bottom surface of the supporting board. Securely clamp board 2 to workbench 3 using two or more "C" clamps, 4 as shown (Fig. [. . . ] contact the nearest Factory Service Center or Authorized Service Station or other competent repair service. Use only identical replacement parts, any other may create a hazard. After five hours of operation, the blade elevation/tilting mechanism should be checked for looseness, binding, or other abnormalities. Disconnect the saw from the power source, turn the saw upside down and pull up and down on the motor unit. [. . . ]