User manual SKIL 3800-02

[. . . ] "READ ALL INSTRUCTIONS" -- Failure to follow the SAFETY RULES identified by BULLET (l) symbol listed BELOW and other safety precautions, may result in serious personal injury. cluttered benches and dark areas invite accidents. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. Power tools create sparks which may ignite the dust or fumes. [. . . ] S To avoid electrical shock, do not expose to rain or use in damp locations. s When servicing use only identical replacement parts. E152254 s For bevel or compound cutting, adjust sliding fence clear of blade path and guard system. Should be no Gap or Overlap when Square is Flipped Over in Dotted Position Disconnect plug from power source before performing any assembly, adjustment or repair to avoid possible Should be avoirGap or Overlap Il ne doit y no aucun écartement when Square is Flipped Over in ou chevauchement lorsque l'équerre est renversée à la Dotted Position position en tirets. Draw Light Trace una línea ligera Line on a lo largo sobre la tablaBoard de este borde Along this Edge CAUTION lock knob in 45° left or right position. Lock head assembly in the down position. Never carry the tool by the cord or head assembly power switch handle. Model 3800 Compound Miter Saw is shipped complete in one box. Separate all parts from packing materials and check each one with the "Table of Loose Parts" to make sure all items are accounted for before discarding any packing material. WARNING power cord or turn the switch on until the Missing parts are obtained and are installed correctly. If any parts are missing, do not plug in Disconnect plug from power source before performing any assembly, adjustment or repair to avoid possible injury. Note: Clean blade of any excess oil before installation. Loosen, but do not remove, the cover plate screw 2 using a Phillips or straight screwdriver (Figure 2). Use the large hex wrench to remove the blade bolt 4 by turning wrench clockwise. NOTE: The blade screw has a left hand thread. To install the 10" blade, fit blade between the chip deflectors 8 and onto the inner washer shoulder 9 (Figure 3 & 4). NOTE: Make sure the rotation arrow on the blade matches the clockwise rotation arrow on the lower guard. To avoid injury, do not use a blade larger or smaller than 10" diameter and 5/8" Press the arbor lock and tighten blade bolt 4 securely, but do not overtighten. Never use saw without cover plate securely in place. Lower guard will not Be sure the arbor lock is released so the blade turns freely. After installing a new blade, lower the blade into the table slot and check for any contact with the base or turn table structure. NOTE: New inserts need to be cut initially to provide blade clearance. [. . . ] NOTE: If installing the existing brush or brushes, make sure the brush goes in the same way it came out. Otherwise a break-in period will occur that will reduce motor performance and increase brush wear. To avoid accidents always disconnect the tool from the power supply before cleaning or performing any maintenance. The tool may be cleaned most effectively with compressed dry air. [. . . ]