User manual SKIL 3855

[. . . ] Distractions can cause you to lose control. 2) ELECTRICAL SAFETY a) Power tool plugs must match the outlet. Do not use any adapter plugs with earthed (grounded) power tools. Unmodified plugs and matching outlets will reduce risk of electric shock. [. . . ] Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts. g) If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards. 4) POWER TOOL USE AND CARE a) Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. b) Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. c) Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tool's operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. g) Use the power tool, accessories and tool bits etc. , in accordance with these instructions, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. 5) SERVICE a) Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. [. . . ] remove hex key W from blade bolt W3 · Replacing table insert TM Replace a defective or worn table insert as follows: !disconnect the plug - remove all 5 screws as illustrated - remove old table insert by first lifting it at the front and then pulling it out completely - place new table insert !firmly tighten all 5 screws · Checking/adjusting of 90° blade alignment £ !disconnect the plug - rotate the saw table to the 0° position and lock in place - lower the tool arm and lock in place - check for a 90° angle between blade and table with a square - if necessary, adjust the 90° blade alignment as follows: 1) loosen three-legged knob N 2) adjust screw N2 with a blade wrench 13 (not standard included) and a 4 mm hex key (not standard included) 3) re-check with square · Checking/adjusting of 45° blade alignment ! [. . . ]