User manual SKIL 5850

[. . . ] WARNING below, may result in electric shock, fire and/or serious personal injury. cluttered benches and dark areas invite accidents. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. Power tools create sparks which may ignite the dust or fumes. [. . . ] If the liquid contacts your eyes, flush them with water for a minimum of 10 minutes and seek medical attention. Place charger on flat non-flammable surfaces and away from flammable materials when re-charging battery pack. The charger and battery pack heat during charging. Carpeting and other heat insulating surfaces block proper air circulation which may cause overheating of the charger and battery pack. If smoke or melting of the case are observed unplug the charger immediately and do not use the battery pack or charger. Use of an attachment not recommended or sold by Skil may result in a risk of fire, electric shock or injury to persons. For example, to protect terminals from shorting DO NOT place batteries in a tool box or pocket with When batteries are not in nails, screws, keys, etc. Remove any component projecting from the battery terminals. This symbol designates that this tool is listed by Underwriters Laboratories. This symbol designates that this tool is listed by the Canadian Standards Association. WARNING off position before making any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally. Disconnect battery pack from tool or place the switch in the locked or Tool Model number Voltage rating Charge time Battery pack Charger Voltage rating Maximum Capacities Blade Blade arbor hole Depth of cut at 90° Depth of cut at 45° ATTACHING THE BLADE Disconnect battery pack Do not use wrenches with longer handles, since it may lead to over tightening of the blade stud. VARI-TORQUE CLUTCH This clutching action is provided by the friction of the OUTER WASHER against the BLADE and permits the blade shaft to turn when the blade encounters excessive resistance. If excessive blade slippage occurs, tighten the blade stud a fraction of a turn more (less than 1/8 turn). To attach, push tabs on end of adapter into dust port until it snaps into place. WARNING always position dust port adapter and vacuum hose so that it does not interfere with the lower guard, or the cutting operation at all settings. Switch in the locked or off position before making any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally. Turn BLADE STUD with wrench provided counter-clockwise and remove BLADE STUD and OUTER WASHER (Fig. If the shaft moves while attempting to loosen the blade stud, strike the wrench counter-clockwise to jar BLADE STUD loose. Retract the lower guard all the way up into the upper guard. [. . . ] To charge the battery pack, simply slide battery pack into charger (Fig. Preventive maintenance performed by unauthorized personnel may result in misplacing of internal wires and components which could cause serious hazard. we recommend that all tool service be performed by a Skil Factory Service Center or Authorized Skil Service Station. SERVICEMEN: Disconnect tool and/or charger from power source before servicing. [. . . ]