User manual SKIL 6267

[. . . ] In all of the warnings listed below refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. Failure to follow all instructions listed below may Keep work area clean and well lit. cluttered or dark areas invite accidents. Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust. [. . . ] A spinning drill bit could become entangled with clothing and injury may result. This tool may be used with sanding and polishing disks, grinding wheels, wire wheel and wire cup brushes. These accessories must be rated for at least the speed recommended on the tool warning label. Wheels and other accessories running over rated speed can fly apart and cause injury. Grinding, drilling, and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: · lead from lead-based paints , · Crystalline silica from bricks and cement and other masonry products, and · arsenic and chromium from chemicallytreated lumber. Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles. Some dust created by IMPORTANT: Some of the following symbols may be used on your tool. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the tool better and safer. Rotational speed, at no load Higher number means greater speed Speed is increasing from 0 setting Action in the direction of arrow Type or a characteristic of current Type or a characteristic of current Type or a characteristic of current Designates Double Insulated Construction tools. Grounding terminal Alerts user to warning messages Designates Ni-Cad battery recycling program This symbol designates that this tool is listed to Canadian Standards by Underwriters Laboratories. This symbol designates that this tool is listed by Underwriters Laboratories, and listed to Canadian Standards by Underwriters Laboratories. This symbol designates that this tool is listed by Underwriters Laboratories. This symbol designates that this tool is listed by the Canadian Standards Association. This symbol designates that this tool complies to NOM Mexican Standards. Measures reduce the risk of starting the tool accidentally. Disconnect the plug from the power source before making any NR = Not recommended ATTENTION: 3/8 inch drills are not recommended for running lag bolts NOTE: For tool specifications refer to the nameplate on your tool. * NOT AVAILABLE ON ALL MODELS VARIABLE SPEED CONTROLLED TRIGGER SWITCH Your tool is equipped with a variable speed trigger switch. The tool can be turned "ON" or "OFF" by squeezing or releasing the trigger. The speed can be adjusted from the minimum to maximum nameplate RPM by the pressure you apply to the trigger. [. . . ] If heavier pressures are used, the wires will be overstressed, resulting in a wiping action; and if this is continued, the life of the brush will be shortened due to wire fatigue. Apply the brush to the work in such a way that as much of the brush face as possible is in full contact with the work. If both hands are holding the drill, they cannot be cut by the hole saw. Hole saws are Ideal for use with lock installation kits for 2-1/8" deadbolts or locksets with 15/16" or 1" latch hole in wooden and composition doors. [. . . ]