User manual SKIL 7305

[. . . ] WARNING and instructions may result in electric shock, fire and/or serious injury. Read all safety warnings and instructions. The term "power tool" in all of the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. Work area safety Keep work area clean and well lit. [. . . ] Proper interpretation of these symbols will allow you to operate the tool better and safer. Name Volts Amperes Hertz Watt Kilograms Minutes Seconds Diameter No load speed Revolutions or reciprocation per minute Off position Selector settings Infinitely variable selector with off Arrow Alternating current Direct current Alternating or direct current Class II construction Earthing terminal Warning symbol Li-ion RBRC seal Rotational speed, at no load Revolutions, strokes, surface speed, orbits etc. Higher number means greater speed Speed is increasing from 0 setting Action in the direction of arrow Type or a characteristic of current Type or a characteristic of current Type or a characteristic of current Designates Double Insulated Construction tools. Grounding terminal Alerts user to warning messages Designates Li-ion battery recycling program Designates Ni-Cad battery recycling program Alerts user to read manual IMPORTANT: Some of the following symbols may be used on your tool. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the tool better and safer. This symbol designates that this tool is listed by Underwriters Laboratories. This symbol designates that this tool is listed by Underwriters Laboratories, to United States and Canadian Standards. Insert round portion of the attachment into the mounting boss from the side of pad (Fig. NOTE: Round portion of the attachment must be fully inserted into the mounting boss in order for the rear end of attachment plate to clear adjustment rail (Fig. Push attachment further under the mounting boss. Lift up on release tab, swing attachment to notch and release tab. To change position of attachment, simply lift release tab, swing attachment to desired notch and release tab to secure attachment (Fig. Swing attachment in direction of arrow C flat against pad until rear portion of attachment slides underneath the the adjustment rail (Fig. Hold the tool with both hands while starting the tool, since torque from the motor can cause the tool to twist. RELEASING AND INSERTING BATTERy PACK Release battery pack from tool by pressing the battery release button and sliding pack out of To insert battery, align battery and slide battery pack into tool until it locks into position. The battery pack accepts only about 80% will be lower. Normal capacity will be restored of its maximum capacity with its first few in two or three charge/discharge cycles. However, after the first few Remember to unplug charger during storage charge cycles, the battery will charge to full period. Check for voltage at outlet by plugging the battery only when the battery in some other electrical device. Light switch which turns power "off" when 3. a substantial drop in operating time per lights are turned off. [. . . ] SERVICEMEN: Disconnect tool and/or charger from power source before servicing. BATTERIES Be alert for battery packs that are nearing their end of life. If you notice decreased tool performance or significantly shorter running time between charges then it is time to replace the battery pack. Battery packs last longer and re-charge better when they are stored discharged. [. . . ]