User manual SKIL 7492

[. . . ] WARNING and instructions may result in electric shock, fire and/or serious injury. Read all safety warnings and instructions. The term "power tool" in all of the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool. Work area safety Keep work area clean and well lit. [. . . ] Holding the work by hand or against your body is unstable and may lead to loss of control. develop a periodic maintenance schedule for your tool. When cleaning a tool be careful not to disassemble any portion of the tool since internal wires may be misplaced or pinched or safety guard return springs may be improperly mounted. The power cord must only be serviced by a Skil Factory Service Center or Authorized Skil Service Station. Drilling, and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: · lead from lead-based paints , · Crystalline silica from bricks and cement and other masonry products, and · arsenic and chromium from chemicallytreated lumber. Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles. Some dust created by power Accidental start-ups may occur if sander is plugged in while changing an accessory. Your tool is equipped with a dust canister, empty it frequently, after completion of sanding and before storing the sander. Be extremely careful of dust disposal, materials in fine particle form may be explosive. do not throw sanding dust on an open fire. Combustion from mixture of varnishes, lacquers, polyurethane, oil or water with dust particles can occur if there is a static discharge, spark introduced in the box, or excessive heat. Always wear eye protection and a dust mask for dusty applications and when sanding overhead. Sanding particles can be absorbed by your eyes and inhaled easily and may cause health complications. liquids entering the motor housing are an electrical shock hazard. Do not use PSA pad on random orbit sanders whose speed exceeds 12, 000/min. Exceeding the maximum operating speed of pad may cause pad to rupture or fly apart during use, striking user or bystanders. do not use sandpaper intended for larger sanding pads. Larger sandpaper will extend beyond the sanding pad causing snagging, tearing of the paper or kick-back. Extra paper extending beyond the sanding pad can also cause serious lacerations. clamp or secure workpiece when sanding. [. . . ] do not throw sanding dust on an open fire. Combustion from mixture of varnishes, lacquers, polyurethane, oil or water with dust particles can occur if there is a static discharge, spark introduced in the box, or excessive heat. REMOVING AND INSTALLING DUST CANISTER To remove dust canister, rotate canister so that slot is in line with pin and simply pull away from the dust port (Fig. To install dust canister, align dust port with hole in canister, push canister onto dust port and rotate until it locks into place. [. . . ]