User manual SKODA RADIO NAVIGATION SYSTEM SATCOMPASS FOR SUPERB

[. . . ] SIMPLY CLE VER SkodaAuto RADIO NAVIGATION SYSTEM SatCompass Introduction You have opted for a Skoda vehicle, which is fitted with a radio navigation system SatCompass, (designated in the following as navigation system ) - we thank you for your confidence in us. We recommend that you read this Owner's Manual attentively to enable you to become familiar with your navigation system and all that it offers as quickly as possible. Please do not hesitate to contact your Skoda Service Partner or importer should you have any further questions regarding any problems with your navigation system which may arise. Any national legal provisions which vary from the information contained in this Owner's Manual take precedence over the information contained herein. [. . . ] Inserting the CD ­ Slide the CD with the written side facing up into the CD case. Insert the CD as far as possible until it can be drawn in automatically by the navigation system. ­ After the CD was drawn in, the navigation system automatically switches over to CD play function. The play function begins, system oriented after a few seconds with the first track of the CD. ­ "TRACK" and the current track number are shown in the standard field - foreground - of the display. CD functions (internal drive) Select track 1 ­ For selecting a track, press the right or left button A upwards or downwards. Fast station finding (audible) 14 ­ Press the right or left button A for a fast station finding upwards or downards. Playing all tracks on a CD (SCAN) 16 ­ Press the button SCAN A. All tracks on a CD are briefly played in ascending order (10 seconds). "SCAN" is shown in the standard field background - of the display. ­ Press once again the button to interrupt this function. Listening to all tracks of a CD in the random sequence ­ Press the button MIX 18 A. Audio ­ Press the button MIX Taking out the CD ­ Press the button CD fully remove the CD. End CD mode ­ Select the desired range or allow the CD to eject with the button FM 2 5 6 A, TMC A or AM A 10 A, the CD is driven to the initial position. Care18 A once again to interrupt this function. 19 Note Dirt or damage of a CD can lead to difficulties when "reading" the information. The difficulty in reading the error depends on the dirt or on the severity of the mechanical damage. Severe scratches cause reading errors which can make the CD jump or "get stuck". All CDs must be treated carefully and always be stored in a protective case. Audio settings The treble and the bass as well as the volume distribution left/right (balance) and front/rear (fader) can be set in the sound menu. 24 ­ Press the button A, to call up the sound menu. Information on how to use a CD CD to jump Uneven road surfaces and strong vibrations may cause the CD to jump. In such cases wait with the CD mode until there is a better road surface to drive on. Formation of condensation When it is cold and after rain showers, moisture can deposit in the CD drive (condensation). This can effect the CD jump or impair the play function. In such cases wait until the moisture has dissipated. Notes for the care of the CDs If a CD is soiled, please never clean the CD in the direction of a circle but rather with a soft fluffly cloth from inside to outside. In case of severe layers of dirt we recommend to clean the CD with a commercially available CD cleaner. Also in this case do not clean the CD in the direction of a circle but rather from inside to outside and then let it dry off. ­ You can select the menu points to be selected one after each other 25 with the menu knob A. 25 ­ Set and confirm the new values with the menu knob A. 27 A. ­ The setting is reset by pressing the button ­ After all settings have been carried out, exit the sound menu by 27 pressing the button A or a an audio source button CD, FM, AM or TMC. Note · · The settings for treble and bass can be carried out and stored individually for each audio source, the settings for balance and fader apply to all audio sources. [. . . ] 34 Travel guide In order to use the travel guide, a navigation CD with travel guide is required. ­ Mark and confirm the menu point "TRAVEL GUIDE" fig. 34 in the 25 navigation basic menu with the menu knob A. The travel guide basic menu is called up. With the travel guide you can call up the travel information to destinations stored under columns. Note For automatic tailback function the navigation system always calculates a time optimized route; i. e. [. . . ]