User manual SKULLCANDY BLUNT MP3 PLAYER

[. . . ] 3. Push back the crown and the second hand starts sweeping. Battery recharging Recharging is needed when power indicator (POWER light) is flashing per 0. 5 second or off. 1£© Connect the watch to PC through USB cable or through optional adaptor to AC power for recharging (ref. [. . . ] to Figure Battery recharging') Crown 12 2£©Recharging light£¨ CHARGE£© lights up ----under recharge 3£© Recharging light£¨ CHARGE£© lights weakly----slow recharge 4£© Recharging light£¨ CHARGE£© off----recharge over ¡ù Note: a£© The battery will be recharged slowly when close to full power and the product can work by then. b£© slow recharge is indicated by CHARGE light when reNo charged through PC. c£© Output voltage should be 5V 0. 25V, when recharging the MP3 output electric current 500mA. Plug into 100v-240v AC power Plug into the USB port Battery recharging 13 III INSTALLATION OF MP3 PLA YER System requirements IBM compatible personal computer Pentium 166 MHz MMX or faster Windows98SE/ME/2000/XP USB port (Universal Serial Bus) Mac Os X/Mac Os 9. 0 64MB RAM or more 20MB free hard-disk space or more 4 x CD-ROM drive or more Accessible to Internet (Recommended) ¡ù Note: User name has to be set as administrator under Windows2000 USB connection 1. USB port on your PC is used for sending files and battery recharging. 2. Check the USB port on your PC referring to its hardware instruction manual. 3. USB light and CHARGE light are lighted when the product connected to PC through USB port. 4. Under Win98 SE make sure the driver MP3 Player utilities enclosed in the packing is successfully installed before connecting the product to PC. 14 Installation guide Install the driver MP3 Player: Put the installation CD into CD-ROM Drive and then it will be installed automatically. The following window will pop up: Click Next button and the window below will pop up 15 Click Yes button to continue 16 Select the installation folder and then click Next 17 Click Next to start installation 18 Installation completed 19 Click Finish and restart your PC according to the PC requirement 20 Firmware download: 1. Make sure the MP3 player utilities is successfully installed 2. Connect the product to PC 3. Click (start) (program) (MP3 Player Utilities) (Firmware Download) the following window will pop up Click Start and the window below will pop up 21 Click Close to complete the download 22 ¢ô CAUTIONS 1. Do not disassemble or change any part of the product that is not mentioned in this manual. 2) Take out spare springs from the case with your tweezers. 25 4. Place the new USB plug: 1) Place the springs from the plastic package into the four spring holes. 2) Make sure there are springs in all four spring holes. Press the new USB plug onto the case in vertical direction as arrow shows. Make sure it fits well on the case. 26 5. Fixing the case: Put back the two screws up on the case to fix new USB plug. The replacement is now finished. 27 ¢ö HELPFUL TIPS Problem Unable to play MP3 Unable to download music Unable to do voice recording No Drive Letter Analysis Battery low Not standard MP3/WMA files Battery low USB cable broken or not connected properly. No space for more recording files The USB plug not connected or loose. The Manager Software not installed successfully. [. . . ] The Manager Software not installed successfully. The PC motherboard does not support USB port. MP3 file made at compression level exceeding 320kbps. [. . . ]