User manual SKY HD BOX

[. . . ] Once you can reach all of the connections at the rear, unplug and set aside your Sky± box, replacing it with your new Sky±HD box. Remove SCART cable You can remove the SCART cable completely from your TV, it will be replaced by your HDMI cable. Remove SCART cable Connect telephone line Connect telephone line Note: Be careful to not insert your telephone line into the green Ethernet socket. This is the existing telephone line that was used to connect your Sky± box. If this is currently not in place, please ensure you connect a telephone line so that you can activate your viewing card and channels in step 4. Connect satellite cables Connect satellite cables These are the existing satellite cables that were used to connect your Sky± box to your satellite dish. [. . . ] For a demonstration on how to navigate around your new TV Guide please visit www. sky. com/hdguide. Press the services button at the top of your Sky±HD remote control and press the right arrow once to navigate from options to settings. Press select, and the tab showing picture should now be highlighted. 2. On your Sky±HD remote type 0 and then 1 on the numeric keypad, then press select, the set-up tab should now be highlighted. Press the right arrow five times to navigate to install (this changes to New Install once selected) and press select. 3. Follow the on screen instructions until Installation Complete is displayed and press select to continue. 7 Activating your channels 1. Press the interactive button at the top of your Sky±HD remote control. Highlight Sky Active on the menu, then press select. Follow the on-screen instructions to complete your set-up. 2. Scroll up or down highlighting My Account & Help, then press select. 3. Highlight Activate self set-up, then press select. 8 Troubleshooting I'm seeing the `No satellite signal is being received' or the `Failed recording' message Check to see if you only have one satellite connection at the back of your box. If so, please refer to the `I only have one satellite connection from the dish to my Sky±HD box' section on page 10. If you have two satellite connections, please follow the instructions below. Press the services button on your Sky±HD remote control, then press the right arrow to move from options to settings, press select, and the picture should now be highlighted. Press the right arrow three times to navigate to signal. If the cables are connected correctly you should see an indication of signal strength and signal quality at Inputs 1 and 2. If you do not have any signal strength or quality, switch the Sky±HD box and TV to standby, leave for a couple of minutes, then switch all the connected items off and unplug from the mains. Checking signal strength and quality 4. Disconnect and then reconnect the cables coming from your satellite to Dish Input 1 and Dish Input 2 at the back of your box. These are screw connectors; turn clockwise to tighten and anti-clockwise to loosen. Do not bend the copper wire in the middle of the satellite cable and ensure you screw the connection onto the back of the box until it is secured tightly. Plug in and switch all products on again and confirm that the signal test screen shows the correct results by following these instructions again. Reconnecting your satellite cables to your box 9 Check that your telephone line is connected to the Tel Line socket I cannot see the Installation Complete message Press the services button on your Sky±HD remote control, then press the right arrow to move from options to settings. Press the right arrow 3 times to navigate to signal, and press select. [. . . ] On your Sky±HD remote type 0 and then 1 on the numeric keypad at the bottom of the remote then press select, and the setup tab should now be highlighted. Press the right arrow 3 times to navigate to RF outlets and press select. Press the down arrow to navigate to RF outlet power supply. Change RF outlet power supply to on and press the green button to save the new setting. [. . . ]