User manual SKYPE EP3M

[. . . ] SKYE® AIR CONDITIONING SERVICE EQUIPMENT OWNERS MANUAL MODEL EP3 R12 Recovery/Recycling System WARNING - DO NOT MIX R12 WITH ANY OTHER REFRIGERANT. July 11, 2000 SKYE International Holdings, Inc. 7441 Tower Street Fort Worth, Texas 76118 Phone: (817) 595-0077 FAX: (817) 595-1106 FOR TECHNICAL SUPPORT AND CUSTOMER SERVICE, PLEASE CALL 1-800-722-SKYE (7593) RECORD YOUR EQUIPMENT DETAILS BELOW: MODEL NO. _____________________________________ SERIAL NO. _____________________________________ DATE PURCHASED _____________________________________ PURCHASED FROM _____________________________________ Thank you for choosing SKYE AC Service Equipment. With proper set up and maintenance, your equipment will provide years of trouble free service. [. . . ] Drain the recovered oil into the measuring bottle provided. You may replace this amount of new oil back into the AC system. NOTE: If the unit stops during the recovery process and the red TANK FULL light glows when the ON button is pressed, the tank is full and must be replaced. All new tanks must be evacuated prior to use. TO RECOVER LIQUID REFRIGERANT IMPORTANT: Your manifold gauge set yellow (center) hose must have a Schrader valve depresser installed or an ABB valve with a built in depresser. Connect the manifold gauge set yellow (center) hose to the LIQUID inlet port on the back of the machine and open the storage tank vapor valve. Connect the service hoses to the vehicle AC system and connect the machine to power. Press the green ON button and open both manifold gauge set valves. The machine will control the recovery rate. When the pressure in the AC system drops to approximately 10" VACUUM the compressor will stop. This does not mean all the refrigerant in the system has been recovered as there may be refrigerant trapped in the oil or an accumulator/drier that will slowly evaporate. The compressor will restart automatically and recover this refrigerant. When the gauges remain at 0 PSI or below for at least 2 minutes recovery is complete. Close the gauge set valves and press the red OFF button. Drain the recovered oil into the measuring bottle provided. You may replace this amount of new oil back into the AC system. NOTE: If the unit stops during the recovery process and the red TANK FULL light glows when the ON button is pressed, the tank is full and must be replaced. All new tanks must be evacuated prior to use. AUXILIARY RECYCLING NOTE: The storage tank must be at least 50% full for this function to be effective. Connect the machine to power and press the green ON button. Open the storage tank vapor valve then the liquid valve and allow the machine to run for a minimum of 3 hours. When recycling is complete, close the storage tank liquid valve, allow the compressor to stop automatically then press the OFF button. DO NOT PRESS THE OFF BUTTON WHILE THE COMPRESSOR IS RUNNING. Close the storage tank vapor valve. NON-CONDENSABLE GAS (NCG) VENTING PROCEDURE IMPORTANT: Allow the unit to stand for a minimum of 2 hours prior to venting NCGs. [. . . ] High pressure from noncondensable gases. SOLUTION Connect to a charged system. Open gauge set valves - Check gauge set for proper operation or connection. Vent non-condensables per instruction manual. 11 Recovered oil not drained. Unit loses refrigerant FOR TECHNICAL DIFFICULTIES NOT COVERED OR OTHER ASSISTANCE. [. . . ]