Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual SMART DEVICES DRS-50. We hope that this SMART DEVICES DRS-50 user guide will be useful to you.
Lastmanuals help download the user guide SMART DEVICES DRS-50.
Manual abstract: user guide SMART DEVICES DRS-5005-30-2000
Detailed instructions for use are in the User's Guide.
[. . . ] makes no warranties, express or implied, including warranties of merchantability or fitness for a particular purpose. RETURN POLICY: Factory authorization MUST be obtained before returning any product. A 15% restocking charge will be issued on unused equipment (in original box) that is returned for credit. [. . . ] For 120VAC, R80 and R81 should have zero Ohm resistors. R79, R80 and R81 are located along the right edge of the rack unit circuit board (looking at the back). The DRS-50 fits into a 3. 5 inch rack space (2 standard rack units). Mount the front panel rack unit into a rack space between the cinema processor and amplifiers. Plug the power cable into the rack power strip. Remote unit installation The remote unit should be placed on a table at a comfortable height for the translator. If you are using the provided Fujikon headset, plug the 3. 5mm microphone plug into the jack marked "unbalanced mic". A 12 conductor cable is necessary to connect the remote unit to the rack unit. Special insulation is recommended for the microphone wire pair. A 12 conductor cable with an insulated wire pair is available from SMART (Part# TXLWIRE, specify footage required). Check wires for continuity before running cable between translation booth and projection booth. Once the cable has been satisfactorily placed, wire the provided 12 pin Phoenix connectors to the cables. Make sure the wiring on each end is the same. The suggested wiring diagram with the SMART cable part is as follows (from left to right looking at the back of the rack unit at connector TB2):
USER'S GUIDE PIN 1 2 3 4 5 6 7 8 9 10 11 12 SIGNAL ON/OFF V+ VGND MIC LHEAD RHEAD GND ICM VOX MAN GND WIRE COLOR GREEN RED BLUE BLACK (insulated pair) RED (insulated pair) PURPLE YELLOW RED\BLACK ORANGE RED\WHITE BROWN BLACK
7
Make sure the remote unit's VOX/MAN/OFF knob is set to the OFF position. Plug the Phoenix connectors into the rear of the rack and remote units. Using the provided 6 pin Phoenix connector plug, connect the output of the cinema processor's dialog channel (usually CENTER) to pins 1 (IN) and 2 (GND) of connector TB1 on the rack unit. [. . . ] While this button is pushed, the VOX detection circuit is deactivated. Pressing this button engages the dubbing action. This LED indicates when the TransLingual is in dubbing mode. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SMART DEVICES DRS-50
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual SMART DEVICES DRS-50 will begin.
