User manual SMART DEVICES MOD IV INSTALLATION PART 1

[. . . ] Press the down arrow key to move down to MPTray Config. Press the down arrow key to move down to Media Type. Press the down arrow key to move down to Card Stock. An asterisk appears next to your selection. [. . . ] Press the down arrow key to select Print Information. The Configuration report prints and the printer goes back on line. To access this menu you must enter the password. Always make sure the media setting matches the print media you are using. If you have a System Administrator, only they can reset the defaults. Press the down arrow key to move down to Admin Setup. Press the up arrow key (a to z, 0 to 9) or the down arrow key (9 to 0, z to a) to scan through the various numbers and letters of the alphabet. Repeat a and b above for each digit of the password. Press the down arrow key to move down to Settings. Temporarily Changing the Media Weight for an Individual Print Job If you are printing a job on special media, you can temporarily load the media in a tray and change the media settings for that tray in the driver as you print the job. Cover them to protect them Entering the fuser, separate the trailing edge of the sheet from the belt, pull the fuser pressure release lever (1) towards the front and remove the sheet. Press release lever (1) and pull the trapped paper from the fuser. Replace the fuser unit and push the lock levers toward the rear of the printer. Push the two retaining levers (1) towards the front of the printer to release the fuser. Drums/toners, being careful to install them in the proper sequence. Open the duplex unit cover and remove any sheets. Lower the printer cover to Protect the image drums from light, but do not latch it. Lift the front cover release Pull out the paper tray and Close the front cover. Press down on the printer For printers equipped with the optional second paper tray: Pull out the second paper tray and remove any jammed paper. The display shows information that will help you correct the error, including clearing paper jams. [. . . ] Press down on the printer For printers equipped with the optional second paper tray: Pull out the second paper tray and remove any jammed paper. The display shows information that will help you correct the error, including clearing paper jams. Use the ON LINE key to move through the Help information. For more information on clearing paper jams, see "Clearing Media Jams" on page 15. [. . . ]